Pioneer DVH-P5900MP Selecting a cross-over frequency, Adjusting the speaker output, Levels

Available accessories

6Press BAND to return to the playback display.

Note

When playing a 2-channel mono source with Pro Logic II turned on, there may be occasions when the following will occur:

!No audio is outputted if the center speaker setting is SML or LRG and no center speaker is installed.

!Audio is heard only over the center speaker if installed and the center speaker setting is SML or LRG.

Selecting a cross-over frequency

You can select a frequency, under which sounds are reproduced through the subwoo- fer. If the installed speakers include one whose size has been set to SML, you can select a fre- quency, under which sounds are reproduced through a LRG speaker or subwoofer.

1Press AUDIO and hold until AT EQ ap- pears in the display, then press AUDIO to select HPF.

2Press cor dto select the speaker to be adjusted.

Each press of cor dselects the speaker in the following order:

F (front speakers)—C (center speaker)—R (rear speakers)—S (subwoofer)

3Press aor bto select cross-over fre- quency for the selected speaker.

Each press of aor bselects cross-over fre- quencies in the following order:

63—80—100—125—160—200 (Hz)

4Press BAND to return to the playback display.

Section

04

Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer’s L.P.F. (low-pass
filter) and that of the SML speaker H.P.F. (high-	Available
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to OFF and other
speakers are set to LRG or OFF.	accessories
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.

1Press AUDIO and hold until AT EQ ap- pears in the display, then press AUDIO to select FRT-L.

2Press cor dto select the speaker to be adjusted.

Each press of cor dselects the speaker in the following order:

FRT-L (front speaker left)—CENTER (center speaker)—FRT-R (front speaker right)— REAR-R (rear speaker right)—REAR-L (rear

speaker left)—SUB.W (subwoofer)

# You cannot select speakers whose size is set at OFF. (Refer to Setting the speaker setting on the previous page.)

3Press aor bto adjust the speaker out- put level.

Each press of aor bincreases or decreases the speaker output level. +10 to –10 is dis- played as the level is increased or decreased.

4Press BAND to return to the playback display.

En 77