Pioneer DVH-P5900MP operation manual Error messages, Dsp

Appendix

Additional Information

DSP

Symptom	Cause	Action (See)
Speakers are not available to be	Their size settings is at OFF.	Make the correct size settings. (Page 76)
adjusted.

Time alignment is not available. Listening position is not set cor- rectly.

Set listening position correctly. (Page 70)

	Speaker size settings is at OFF.	Make the correct size settings. (Page 76)
The subwoofer is not available to	The subwoofer is set to OFF.	Set the subwoofer to ON. (Page 76)
switch its phase.
Bass content is not heard.	The subwoofer is set to OFF and yet	Make the correct settings. (If no subwoofer is
	other speakers are set to OFF or	installed, the front or rear speaker needs to
	SML in size.	be set to LRG.) (Page 76)
Ocassionally no sounds are out-	The center speaker setting is at SML	Change the center speaker size setting to
put when Dolby Pro Logic II is	or LRG whereas no center speaker	OFF. (If the audio source is mono and Dolby
turned on.	is installed.	Pro Logic II is turned on, sound is heard over
		the center speaker only.) (Page 76)
Occasionally no sounds are	Dolby Pro Logic II is turned on.	Turn Dolby Pro Logic II off. (If the audio
heard over speakers other than		source is mono and Dolby Pro Logic II is
the center one.		turned on, sound is heard over the center
		speaker only.) (Page 70)
Turning dynamic range control	The currently reproduced sound is	The feature is only effective on Dolby Digital
on has no effects.	not Dolby Digital coded.	sounds. (Page 71)
No sounds are heard.	Optical cables are incorrectly con-	Connect the cables correctly.
	nected.

Additional Information

Error messages

When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error message.

Message	Cause	Action
ERROR02-XX	Dirty disc	Clean disc.
	Scratched disc	Replace disc.
	The disc is loaded upside down	Check that the disc is loaded correctly.
R ERROR	The disc does not have the same re-	Replace the DVD video with one bearing the
	gion number as this unit	correct region number.
NON-PLAY	This type of disc cannot be played	Replace the disc with one this unit can play.
	by this unit
HEAT	The temperature of this unit is out-	Wait until the unit’s temperature returns to
	side the normal operating range	within normal operating limits.

En 83