Onkyo USR-5RF instruction manual IR commands Device pages

Page 18

Getting Started

Using the Left and Right button

Using the direct-access buttons

The Left and Right buttons change function depending on the device the remote controller is operating. The current function is displayed on the touchscreen right above the button. The function can be either an IR (infrared) command that is transmitted, or a jump to a specific device page.

IR commands

Device pages

MUTE, CH and VOL can be operated at any time, even without turning on the touchscreen.

18

Image 18

Contents USR-5RF Precautions CareTable of contents Touch the screen to start Quick StartInsert batteries Operate your componentsQuick reference Quick referenceQuick reference ModesIntelligent Remote Controller Direct-access buttonsIntroduction Left and Right buttons Touchscreen buttonsWhich Buttons Can Be Programmed? Charging the Remote Controller AA batteriesOptional recharging dock Activate the remote controller Getting StartedDefine the Brand of Your Device Defining brands by selecting Select Yes to define the brand of the device to operateTap Next Navigate through the list of brands Select your brand from the listSelect a code set from the list Defining brands by searching Tap SearchSelect a Device Via the Home menuVia the Device menu Operate a Device Using touchscreen buttonsSending commands ScrollingIR commands Device pages Tap the button of the setting you want to adjust Adjust the SettingsTouch and hold the remote controller icon for a few seconds Use the Left and Right button to adjust the settingSecond setup panel Third setup panelGetting the Maximum out of it IntroductionWorking with Modes Tap the mode you want to use To hide the Mode menuTap Programming Buttons Programming control panel buttonsProgramming direct-access and Left/Right Buttons Programming device itemsMake sure the device tab is active Labeling Buttons and Menu Items Labeling a buttonEdit the label Labeling a menu item Complete instruction 4 to 6 Labeling a button onAdding and Moving Devices Adding devicesMoving menu items Delete and restore DeleteDeleting a button or button function Restore Tap the item you want to restoreRecording Macros and Setting Timers Recording macrosSetting timers Editing macrosEdit the timer Press the Left button to close the timer Editing timersOrganizing macros and timers into groups Tap Create Timer Group or Create Macro GroupUsing the remote controller with Radio Frequency Changing the remote controller’s RF IR Settings Switch to RF IR mode by using Mode buttonTap RF Try the devices which you just changed the RF IR settings Changing the Extender IDChoosing Another Channel Switch back to RF IR modeSelect a device that is set with RF signals Press the + and action buttons to change the ChannelChadEdit With ChadEdit you canSystem requirements Troubleshooting General Problems Programming ProblemsRecharging Problems How do I reset the Remote controller? Can I program a button to execute more than one command?How do I program source switching? How do I revert to the original configuration?Overview of Symbols Specifications Onkyo U.S.A. Corporation