Onkyo USR-5RF Labeling a menu item, Complete instruction 4 to 6 Labeling a button on

Page 26

Getting the Maximum out of it

5.Tap Enter to save the changes and return to the panel you were. -or-Tap Cancel to return to the panel you were without saving changes.

6.Label all other items you want and return to Use mode via the Mode button.

Labeling a menu item

1.Switch to Label mode by using the Mode button.

2.Tap the device tab to open the Device menu.

3.Touch and hold either the remote controller’s Left or Right button and tap the device you want to program.

Even when you want to program the currently active device, you have to tap it in the Device menu.

4.Complete instruction 4 to 6 in

“Labeling a button” on page 25.

Image 26

Contents USR-5RF Precautions CareTable of contents Touch the screen to start Quick StartInsert batteries Operate your componentsQuick reference Quick referenceQuick reference ModesIntroduction Intelligent Remote ControllerDirect-access buttons Which Buttons Can Be Programmed? Left and Right buttonsTouchscreen buttons Charging the Remote Controller AA batteriesOptional recharging dock Define the Brand of Your Device Activate the remote controllerGetting Started Tap Next Defining brands by selectingSelect Yes to define the brand of the device to operate Navigate through the list of brands Select your brand from the listSelect a code set from the list Defining brands by searching Tap SearchVia the Device menu Select a DeviceVia the Home menu Operate a Device Using touchscreen buttonsSending commands ScrollingIR commands Device pages Tap the button of the setting you want to adjust Adjust the SettingsTouch and hold the remote controller icon for a few seconds Use the Left and Right button to adjust the settingSecond setup panel Third setup panelWorking with Modes Getting the Maximum out of itIntroduction Tap Tap the mode you want to useTo hide the Mode menu Programming Buttons Programming control panel buttonsMake sure the device tab is active Programming direct-access and Left/Right ButtonsProgramming device items Edit the label Labeling Buttons and Menu ItemsLabeling a button Labeling a menu item Complete instruction 4 to 6 Labeling a button onMoving menu items Adding and Moving DevicesAdding devices Deleting a button or button function Delete and restoreDelete Restore Tap the item you want to restoreRecording Macros and Setting Timers Recording macrosSetting timers Editing macrosEdit the timer Press the Left button to close the timer Editing timersOrganizing macros and timers into groups Tap Create Timer Group or Create Macro GroupUsing the remote controller with Radio Frequency Tap RF Changing the remote controller’s RF IR SettingsSwitch to RF IR mode by using Mode button Try the devices which you just changed the RF IR settings Changing the Extender IDChoosing Another Channel Switch back to RF IR modeSelect a device that is set with RF signals Press the + and action buttons to change the ChannelChadEdit With ChadEdit you canSystem requirements Troubleshooting General Problems Programming ProblemsRecharging Problems How do I reset the Remote controller? Can I program a button to execute more than one command?How do I program source switching? How do I revert to the original configuration?Overview of Symbols Specifications Onkyo U.S.A. Corporation