Onkyo USR-5RF instruction manual Changing the remote controller’s RF IR Settings, Tap RF

Page 34

Getting the Maximum out of it

Changing the remote controller’s RF IR Settings

All devices are set up by default to work with IR signals. To be able to operate one or more devices with RF signals, you have to change the remote controller’s RF IR settings for those devices.

1.Make sure the Device tab is active.

The Device tab is active when the name of a device is displayed at the right side of the

touch screen .

2.Switch to RF IR mode by using the

Mode button .

The Device menu appears.

3.Select the device for which you want to change the RF IR settings.

The RF IR settings appear. The white label on

the button indicates that the selected device is currently operated with IR signals.

4.Tap RF.

The RF IR settings for the selected device are transferable from IR to RF.

When you have only one RF Receiver, you can accept the default settings for the Extender ID and the Channel. Continue with step 5.

or

When you have several RF Receivers to operate devices, you have to assign the correct Extender ID to the selected device. Follow the instructions as described in “Changing the Extender ID”.

Note:

The ID on the RF Receiver has to match the Extender ID on the remote controller.

34

Image 34

Contents USR-5RF Precautions CareTable of contents Touch the screen to start Quick StartInsert batteries Operate your componentsQuick reference Quick referenceQuick reference ModesDirect-access buttons Intelligent Remote ControllerIntroduction Touchscreen buttons Left and Right buttonsWhich Buttons Can Be Programmed? Charging the Remote Controller AA batteriesOptional recharging dock Getting Started Activate the remote controllerDefine the Brand of Your Device Select Yes to define the brand of the device to operate Defining brands by selectingTap Next Navigate through the list of brands Select your brand from the listSelect a code set from the list Defining brands by searching Tap SearchVia the Home menu Select a DeviceVia the Device menu Operate a Device Using touchscreen buttonsSending commands ScrollingIR commands Device pages Tap the button of the setting you want to adjust Adjust the SettingsTouch and hold the remote controller icon for a few seconds Use the Left and Right button to adjust the settingSecond setup panel Third setup panelIntroduction Getting the Maximum out of itWorking with Modes To hide the Mode menu Tap the mode you want to useTap Programming Buttons Programming control panel buttonsProgramming device items Programming direct-access and Left/Right ButtonsMake sure the device tab is active Labeling a button Labeling Buttons and Menu ItemsEdit the label Labeling a menu item Complete instruction 4 to 6 Labeling a button onAdding devices Adding and Moving DevicesMoving menu items Delete Delete and restoreDeleting a button or button function Restore Tap the item you want to restoreRecording Macros and Setting Timers Recording macrosSetting timers Editing macrosEdit the timer Press the Left button to close the timer Editing timersOrganizing macros and timers into groups Tap Create Timer Group or Create Macro GroupUsing the remote controller with Radio Frequency Switch to RF IR mode by using Mode button Changing the remote controller’s RF IR SettingsTap RF Try the devices which you just changed the RF IR settings Changing the Extender IDChoosing Another Channel Switch back to RF IR modeSelect a device that is set with RF signals Press the + and action buttons to change the ChannelChadEdit With ChadEdit you canSystem requirements Troubleshooting General Problems Programming ProblemsRecharging Problems How do I reset the Remote controller? Can I program a button to execute more than one command?How do I program source switching? How do I revert to the original configuration?Overview of Symbols Specifications Onkyo U.S.A. Corporation