Onkyo USR-5RF instruction manual Optional recharging dock

Page 10

Introduction

Optional recharging dock

Warning:

Use the recharging dock only with the NiMH rechargeable battery pack of BCC-5.

1.Slide the battery cover off the back of the remote controller.

2.Remove the plastic AA battery tray from the battery compartment.

3.Insert the battery pack (included with the recharging dock) as indicated on the side of the battery pack.

4.Slide the battery cover back on.

After a few seconds, the remote controller starts up automatically and beeps twice to indicate that it has finished starting up.

5.Plug the power adapter into a wallet outlet and connect it to the recharging dock.

6.Place the remote controller on the recharging dock.

Recharging starts automatically. The light on the front of the recharging dock indicates charging takes place. When the battery pack is fully charged, the light goes off.

Notes:

•You can operate the remote controller while it is being charged.

•Normal charging time is 2 to 3 hours, depending on the condition of the battery pack.

When the battery pack is running low, the Low

Battery icon blinks at the center top of the display. Recharge the batteries as soon as possible to ensure perfect performance.

Note:

The remote controller retains all settings when the battery pack has run out. You will only have to reset the clock.

10

Image 10

Contents USR-5RF Precautions CareTable of contents Touch the screen to start Quick StartInsert batteries Operate your componentsQuick reference Quick referenceQuick reference ModesDirect-access buttons Intelligent Remote ControllerIntroduction Touchscreen buttons Left and Right buttonsWhich Buttons Can Be Programmed? Charging the Remote Controller AA batteriesOptional recharging dock Getting Started Activate the remote controllerDefine the Brand of Your Device Select Yes to define the brand of the device to operate Defining brands by selectingTap Next Navigate through the list of brands Select your brand from the listSelect a code set from the list Defining brands by searching Tap SearchVia the Home menu Select a DeviceVia the Device menu Operate a Device Using touchscreen buttonsSending commands ScrollingIR commands Device pages Tap the button of the setting you want to adjust Adjust the SettingsTouch and hold the remote controller icon for a few seconds Use the Left and Right button to adjust the settingSecond setup panel Third setup panelIntroduction Getting the Maximum out of itWorking with Modes To hide the Mode menu Tap the mode you want to useTap Programming Buttons Programming control panel buttonsProgramming device items Programming direct-access and Left/Right ButtonsMake sure the device tab is active Labeling a button Labeling Buttons and Menu ItemsEdit the label Labeling a menu item Complete instruction 4 to 6 Labeling a button onAdding devices Adding and Moving DevicesMoving menu items Delete Delete and restoreDeleting a button or button function Restore Tap the item you want to restoreRecording Macros and Setting Timers Recording macrosSetting timers Editing macrosEdit the timer Press the Left button to close the timer Editing timersOrganizing macros and timers into groups Tap Create Timer Group or Create Macro GroupUsing the remote controller with Radio Frequency Switch to RF IR mode by using Mode button Changing the remote controller’s RF IR SettingsTap RF Try the devices which you just changed the RF IR settings Changing the Extender IDChoosing Another Channel Switch back to RF IR modeSelect a device that is set with RF signals Press the + and action buttons to change the ChannelChadEdit With ChadEdit you canSystem requirements Troubleshooting General Problems Programming ProblemsRecharging Problems How do I reset the Remote controller? Can I program a button to execute more than one command?How do I program source switching? How do I revert to the original configuration?Overview of Symbols Specifications Onkyo U.S.A. Corporation