Onkyo USR-5RF instruction manual Editing macros, Setting timers

Page 31

Getting the Maximum out of it

Editing macros

You can edit any macro you have recorded.

1.Open the macro group that contains the macro.

2.Switch to Edit mode via the Mode button.

3.Tap the macro you want to edit.

The contents of the macro appear.

4.Edit the macro.

You can move or delete listed commands or you can add new commands. You can also add delays to the macro (for example, to insert a short pause between turning on a device and sending commands to it allowing the device to warm up):

1.Tap Delay.

2.Tap or to decrease or increase the length of the delay.

3.Use the arrow buttons and to move the delay to the right place.

5.Press the Left button to close the macro.

A confirmation screen appears, which allows you to save or cancel the macro.

6.Tap Save.

The macro is ready to be used.

Setting timers

To activate a device at the time you set.

1.Tap the Macro menu button.

2.Open the macro menu and select a timer group.

3.Switch to Edit mode by using the Mode button.

Empty timer buttons appear in the timer control panel.

4.Tap the button you want to set a timer for.

The first timer control panel appears in which you can set the start time.

5.Enter the command the timer has to execute.

A timer can contain either a single IR command or a macro.

You can navigate to any control panel you want, just as you can in Use mode.

31

Image 31

Contents USR-5RF Care PrecautionsTable of contents Operate your components Quick StartInsert batteries Touch the screen to startQuick reference Quick referenceModes Quick referenceDirect-access buttons Intelligent Remote ControllerIntroduction Touchscreen buttons Left and Right buttonsWhich Buttons Can Be Programmed? AA batteries Charging the Remote ControllerOptional recharging dock Getting Started Activate the remote controllerDefine the Brand of Your Device Select Yes to define the brand of the device to operate Defining brands by selectingTap Next Select your brand from the list Navigate through the list of brandsSelect a code set from the list Tap Search Defining brands by searchingVia the Home menu Select a DeviceVia the Device menu Scrolling Using touchscreen buttonsSending commands Operate a DeviceIR commands Device pages Use the Left and Right button to adjust the setting Adjust the SettingsTouch and hold the remote controller icon for a few seconds Tap the button of the setting you want to adjustThird setup panel Second setup panelIntroduction Getting the Maximum out of itWorking with Modes To hide the Mode menu Tap the mode you want to useTap Programming control panel buttons Programming ButtonsProgramming device items Programming direct-access and Left/Right ButtonsMake sure the device tab is active Labeling a button Labeling Buttons and Menu ItemsEdit the label Complete instruction 4 to 6 Labeling a button on Labeling a menu itemAdding devices Adding and Moving DevicesMoving menu items Delete Delete and restoreDeleting a button or button function Tap the item you want to restore RestoreRecording macros Recording Macros and Setting TimersEditing macros Setting timersTap Create Timer Group or Create Macro Group Editing timersOrganizing macros and timers into groups Edit the timer Press the Left button to close the timerUsing the remote controller with Radio Frequency Switch to RF IR mode by using Mode button Changing the remote controller’s RF IR SettingsTap RF Changing the Extender ID Try the devices which you just changed the RF IR settingsPress the + and action buttons to change the Channel Switch back to RF IR modeSelect a device that is set with RF signals Choosing Another ChannelWith ChadEdit you can ChadEditSystem requirements General Problems Programming Problems TroubleshootingRecharging Problems How do I revert to the original configuration? Can I program a button to execute more than one command?How do I program source switching? How do I reset the Remote controller?Overview of Symbols Specifications Onkyo U.S.A. Corporation