Onkyo USR-5RF instruction manual Charging the Remote Controller, AA batteries

Page 9

Introduction

2.Charging the Remote Controller

AAbatteries

1.Slide the battery cover off the back of the remote controller.

2.Insert 4 AA batteries (included in package) as indicated on the bottom of the battery compartment.

3.Slide the battery cover back on.

After a few seconds, the remote controller starts up automatically and beeps twice to indicate that it is ready to use.

When batteries are running low, the Low Battery

icon blinks at the center top of the display. Replace the batteries as soon as possible to ensure perfect performance.

Note:

The remote controller retains all settings when batteries have run out or when you replace them. You will only have to reset the clock.

9

Image 9

Contents USR-5RF Care PrecautionsTable of contents Insert batteries Quick StartTouch the screen to start Operate your componentsQuick reference Quick referenceModes Quick referenceIntelligent Remote Controller Direct-access buttonsIntroduction Left and Right buttons Touchscreen buttonsWhich Buttons Can Be Programmed? AA batteries Charging the Remote ControllerOptional recharging dock Activate the remote controller Getting StartedDefine the Brand of Your Device Defining brands by selecting Select Yes to define the brand of the device to operateTap Next Select your brand from the list Navigate through the list of brandsSelect a code set from the list Tap Search Defining brands by searchingSelect a Device Via the Home menuVia the Device menu Sending commands Using touchscreen buttonsOperate a Device ScrollingIR commands Device pages Touch and hold the remote controller icon for a few seconds Adjust the SettingsTap the button of the setting you want to adjust Use the Left and Right button to adjust the settingThird setup panel Second setup panelGetting the Maximum out of it IntroductionWorking with Modes Tap the mode you want to use To hide the Mode menuTap Programming control panel buttons Programming ButtonsProgramming direct-access and Left/Right Buttons Programming device itemsMake sure the device tab is active Labeling Buttons and Menu Items Labeling a buttonEdit the label Complete instruction 4 to 6 Labeling a button on Labeling a menu itemAdding and Moving Devices Adding devicesMoving menu items Delete and restore DeleteDeleting a button or button function Tap the item you want to restore RestoreRecording macros Recording Macros and Setting TimersEditing macros Setting timersOrganizing macros and timers into groups Editing timersEdit the timer Press the Left button to close the timer Tap Create Timer Group or Create Macro GroupUsing the remote controller with Radio Frequency Changing the remote controller’s RF IR Settings Switch to RF IR mode by using Mode buttonTap RF Changing the Extender ID Try the devices which you just changed the RF IR settingsSelect a device that is set with RF signals Switch back to RF IR modeChoosing Another Channel Press the + and action buttons to change the ChannelWith ChadEdit you can ChadEditSystem requirements General Problems Programming Problems TroubleshootingRecharging Problems How do I program source switching? Can I program a button to execute more than one command?How do I reset the Remote controller? How do I revert to the original configuration?Overview of Symbols Specifications Onkyo U.S.A. Corporation