Onkyo USR-5RF instruction manual Recharging Problems

Page 40

Troubleshooting

The Remote controller will not switch modes

•When the batteries are low the Remote controller prevents you from switching to customizing modes so that no customization can get lost. Replace the batteries or recharge the battery pack (see pages 9, 10).

The Remote controller is low on memory

Recharging Problems

The batteries will not recharge

•Make sure you are using the rechargeable battery pack included with your recharging dock and not the AA batteries.

The indicator light blinks

•The remote controller displays a message to clean up the memory. The Remote controller will do this by permanently removing devices and macro and timer groups you have deleted.

Warning:

Cleaning up memory will take 10 minutes or longer. Never remove batteries during the clean- up process. This might damage the configuration file resulting in loss of your customized commands.

The configuration file is corrupted

•When this very unlikely event occurs, you have to revert to the original configuration. All your customized commands devices and macros will be lost and you will have to reprogram your remote controller.

Remote controller error messages

•If one of the following error messages occurs, please contact your dealer or the Onkyo customer service:

•Can not open configuration file

•Configuration file error

•No configuration file found

•Invalid configuration file version

•Check if the contacts on the recharging dock are clean and free of obstructions.

•Make sure the remote controller lies properly on the dock.

•Make sure the battery pack is installed properly in your remote controller (see page 10).

40

Image 40

Contents USR-5RF Precautions CareTable of contents Quick Start Insert batteriesTouch the screen to start Operate your componentsQuick reference Quick referenceQuick reference ModesDirect-access buttons Intelligent Remote ControllerIntroduction Touchscreen buttons Left and Right buttonsWhich Buttons Can Be Programmed? Charging the Remote Controller AA batteriesOptional recharging dock Getting Started Activate the remote controllerDefine the Brand of Your Device Select Yes to define the brand of the device to operate Defining brands by selectingTap Next Navigate through the list of brands Select your brand from the listSelect a code set from the list Defining brands by searching Tap SearchVia the Home menu Select a DeviceVia the Device menu Using touchscreen buttons Sending commandsOperate a Device ScrollingIR commands Device pages Adjust the Settings Touch and hold the remote controller icon for a few secondsTap the button of the setting you want to adjust Use the Left and Right button to adjust the settingSecond setup panel Third setup panelIntroduction Getting the Maximum out of itWorking with Modes To hide the Mode menu Tap the mode you want to useTap Programming Buttons Programming control panel buttonsProgramming device items Programming direct-access and Left/Right ButtonsMake sure the device tab is active Labeling a button Labeling Buttons and Menu ItemsEdit the label Labeling a menu item Complete instruction 4 to 6 Labeling a button onAdding devices Adding and Moving DevicesMoving menu items Delete Delete and restoreDeleting a button or button function Restore Tap the item you want to restoreRecording Macros and Setting Timers Recording macrosSetting timers Editing macrosEditing timers Organizing macros and timers into groupsEdit the timer Press the Left button to close the timer Tap Create Timer Group or Create Macro GroupUsing the remote controller with Radio Frequency Switch to RF IR mode by using Mode button Changing the remote controller’s RF IR SettingsTap RF Try the devices which you just changed the RF IR settings Changing the Extender IDSwitch back to RF IR mode Select a device that is set with RF signalsChoosing Another Channel Press the + and action buttons to change the ChannelChadEdit With ChadEdit you canSystem requirements Troubleshooting General Problems Programming ProblemsRecharging Problems Can I program a button to execute more than one command? How do I program source switching?How do I reset the Remote controller? How do I revert to the original configuration?Overview of Symbols Specifications Onkyo U.S.A. Corporation