Universal Remote Control omega MX-650 owner manual IR/RF Signal Setting, RF Button, Exit this Menu

Universal Remote Control, Inc .

3 Press the RF button.

RF Button

4	The RF Settings Menu appears. See the notes on the following
	pages for more info on each option. Make your selection by press-

ing the button you want:

Signal (IR,

RF or Both)

Emitters - ALL or a specific Emitter

Base Station ID #

Blaster - Turn the Blaster On or Off

Exit this Menu

5	After you’ve made a new setting and SAVED your change, use the
	EXIT button to return to the Setup menu. Use the MAIN button to

return to normal operation.

IR/RF Signal Setting

You can set the signal to be IR line-of-sight only, RF only or IR and RF simultaneously. Additionally, you can set the signal the same way for ALL ten of your devices OR you can set the signal differently for each device (the plasma TV could be set to be IR line-of-sight only, while the DVD player and the Satellite receiver are set to be RF only). A good reason to set the signal to RF only is to prevent too much IR being sent to a sensitive component from two arrivals at the front panel (one directly from the Omega, one from the RF base station). A good reason to set the signal to IR only is that another room has an MRF-100 base station (no RF address) so it will receive commands from the Omega unless it is set to IR only.

31