Universal Remote Control omega MX-650 owner manual Emitt Setting IR Emitter Outputs

	T h e O m e g a
4	Select the new setting by pressing the desired button, then press SAVE
	to save your new setting and return to the RF settings menu.

Displays the current ID#

Change ID# using UP and DOWN buttons

Save the new setting

Exit this Menu with- out changing the IR/RF settings

EMITT - Setting IR Emitter Outputs

The MRF-250 and MRF-300 Base Stations enable you to route or steer the IR commands from any Device to any or all of the IR Line Outputs. This allows you to control identical devices using the exact same IR commands (such as an array of television sets in a media room or a stack of identical satellite receivers installed in a central location with one satellite receiver dedicated to each room with a television). Each button push (or macro step) is rout- ed to the specific IR Line Output you’ve assigned to a device. In the factory set default settings, the Omega is set to route IR com- mands from any device to ALL IR Line Outputs simultaneously. To change the Omega default settings follow these steps:

1 From the RF Settings Menu, select EMITT.

2	Decide whether you are changing the Emitter settings for all devices
	or just one of the devices of the Omega.

Select ALL to change the Emitter settings to ALL devices in the Omega. Then, go to Step 4.

Select DEVIC to change the Emitter settings to just one of the devices in the Omega. Then, go to Step 3.

34