Sunwave Tech SRC-7000 manual Device Setting

Page 21

Chapter 2 Quick Start

2.3 Device Setting

SRC-7000 will automatically get through the setup mode when you operate the SRC-7000 for the first time.

1.Select the targeted device you wish to set up. Please tap the target device key in the Main Menu to enter “Setup device” menu. (ex. “TV” device)

1.

2.

3.

*Pre-code:load pre-programmed IR code from the factory default (no guarantee being able to control all brand devices).

2.Press the or buttons to choose “Yes” item and press button for entering the operation mode.

3. Choose the first letter of targeted device brand (ex. “S” on behalf of Sony, Samsung…etc), and point the SRC-7000 at the targeted device. After selecting “Brand” item, please turn on your target device.

Tap soft button to start auto searching. When you see the targeted device has been turned off, tap or press any

button immediately to stop auto searching. Then press to test the power key. If it can’t work, please go through step as below.

Tap or gently to figure out the correct remote code (Code number as shown on the top middle position of the LCD.) until the targeted device has been turned on again. Press the power key or the hard key to test and to confirm the codes.

19

Image 21

Contents 041201 User’s ManualAbout this manual PrefaceCopyright TrademarksTable of Contents Pre-code Learning Macro Timer MacroInstall the SLC-2080 USB Driver Introduction to the SRC-7000 Unpacking the SRC-7000 SRC-7000 FeaturesRemove battery cover Battery InstallationTurning the Touch Screen On Battery PrecautionsTop of SRC-7000 Identifying ComponentsBotton of SRC-7000 Setup mode function Device normal function Direct Access Buttons Rubber KeysLCD Touch Screen Precautions When Using the Touch ScreenTouch screen buttons Touch Screen KeysMain Menu Basic Information Layout Code Setting Setup Mode Key Layout Setup ModeTimer Macro Setup Mode Re-calibrating the Screen Quick StartDate / Time Setting Device Setting SRC-7000 User’s Manual How to Set Up Your SRC-7000 Add a DeviceCreate a New Device Next row Load the Codes for the Newly-added Device How to Set Up Your SRC-7000SRC-7000 User’s Manual Learning SRC-7000 User’s Manual Add a Soft Key SRC-7000 User’s Manual Adding Text Re-label a Device, Key or Text How to Set Up Your SRC-7000 Re-size a Device, Key or Text Delete a Device, Key or Text SRC-7000 User’s Manual Pre-programmed Code SRC-7000 User’s Manual Learning SRC-7000 User’s Manual Learning successfully Learning fail Learn a Cycle Key Delete Device / Key Codes Macro Create a MacroIf you intend to create another Macro key, please repeat ~5 Basic Device Required Macro Sequence Operation An Example of setting a MacroCreate a Timer Macro Timer MacroSRC-7000 User’s Manual Delete Your Timer Macro Re-label Your Timer Macro View Your Timer Macro Add Favorite Channel Keys Set Up Your Favorite ChannelsNop Set Your Favorite Channels as MacrosMenus Set Up the RemoteTime PowerContrast DateLCD Off Light SensitivityLight Period Motion ResetKey Layout Code Setting View Timer MacroDuplicate DuplicateSRC-7000 User’s Manual Install USB Cable and Software Install the SLC-2080 USB DriverIntroduce SLC-2080 USB Cable SRC-7000 User’s Manual Install Upgrade Tools SRC-7000 User’s Manual Install USB Cable and Software Upgrade Vmcu Firmware and Vmcf Pre- programmed Codes Backup Remote From InternetFrom File SRC-7000 User’s Manual Appendix a FeaturesCD, AUX SpecificationsAppendix B Optional AccessoriesSLC-2080 USB Cable Transmit Cable SDS-7000 SDS-7000 Docking StationAppendix C Troubleshooting TablesTrying to configure