Sunwave Tech SRC-7000 manual Quick Start, Re-calibrating the Screen

Page 19

Chapter 2 Quick Start

This chapter shows you how to quickly set up the SRC-7000, for a more detailed set up please refer to Chapter 3.

At turn on, the SRC-7000 will show the welcome greeting message on the screen. From now on, you formally enter the setup procedure. Please operate by the following instructions step by step.

2.1 Re-calibrating the Screen

You will need to re-calibrate SRC-7000’s touch panel in three conditions:

a.When you insert the batteries at the first time.

b.When you reset the SRC-7000.

c.When you feel the SRC-7000’s touch panel is not so sensitive. Please follow the instruction as below:

1.Press button for 2 seconds to enter Setup Menu.

2.Scroll the or buttons to choose Setting item and press button for entering “Setting” menu.

3.Scroll the or buttons to select Calibrate item and

press button for entering “Calibrate Panel” for screen calibration.

4.Tap the 5 “” places following screen indication step by step. When finished, the screen will go back to previous “Setting” menu automatically.

2.

3.

4.

When you finish tapping these 5 indicators, the re-calibration

process is completed. Then press two times to exit setup mode.

17

Image 19
Contents 041201 User’s ManualTrademarks PrefaceAbout this manual CopyrightTable of Contents Pre-code Learning Macro Timer MacroInstall the SLC-2080 USB Driver Introduction to the SRC-7000 Unpacking the SRC-7000 SRC-7000 FeaturesRemove battery cover Battery InstallationTurning the Touch Screen On Battery PrecautionsTop of SRC-7000 Identifying ComponentsBotton of SRC-7000 Setup mode function Device normal function Direct Access Buttons Rubber KeysLCD Touch Screen Precautions When Using the Touch ScreenTouch screen buttons Touch Screen KeysMain Menu Basic Information Layout Code Setting Setup Mode Key Layout Setup ModeTimer Macro Setup Mode Re-calibrating the Screen Quick StartDate / Time Setting Device Setting SRC-7000 User’s Manual Add a Device How to Set Up Your SRC-7000Create a New Device Next row Load the Codes for the Newly-added Device How to Set Up Your SRC-7000SRC-7000 User’s Manual Learning SRC-7000 User’s Manual Add a Soft Key SRC-7000 User’s Manual Adding Text Re-label a Device, Key or Text How to Set Up Your SRC-7000 Re-size a Device, Key or Text Delete a Device, Key or Text SRC-7000 User’s Manual Pre-programmed Code SRC-7000 User’s Manual Learning SRC-7000 User’s Manual Learning successfully Learning fail Learn a Cycle Key Delete Device / Key Codes Macro Create a MacroIf you intend to create another Macro key, please repeat ~5 Basic Device Required Macro Sequence Operation An Example of setting a MacroCreate a Timer Macro Timer MacroSRC-7000 User’s Manual Delete Your Timer Macro Re-label Your Timer Macro View Your Timer Macro Add Favorite Channel Keys Set Up Your Favorite ChannelsNop Set Your Favorite Channels as MacrosMenus Set Up the RemoteDate PowerTime ContrastLight Sensitivity LCD OffLight Period Motion ResetKey Layout Code Setting View Timer MacroDuplicate DuplicateSRC-7000 User’s Manual Install the SLC-2080 USB Driver Install USB Cable and SoftwareIntroduce SLC-2080 USB Cable SRC-7000 User’s Manual Install Upgrade Tools SRC-7000 User’s Manual Install USB Cable and Software Upgrade Vmcu Firmware and Vmcf Pre- programmed Codes From Internet Backup RemoteFrom File SRC-7000 User’s Manual Appendix a FeaturesCD, AUX SpecificationsSDS-7000 SDS-7000 Docking Station Optional AccessoriesAppendix B SLC-2080 USB Cable Transmit CableAppendix C Troubleshooting TablesTrying to configure