Best IS23 manual Operation, Light Bulbs, Controls

REMOVE LIGHT LENS COVER

OPERATION

Controls

The hood is operated using the (4) push- buttons located at eye-level, on the front edge of the hood.

The light switch turns the lights on and off.

The blower on-low / off switch turns the blower on to its lowest running speed. The blower must be turned on using this switch. Turn the blower off by pressing this switch a second time.

BLOWER

LIGHT MEDIUM

SWITCH SPEED

BLOWER	BLOWER
ON-LOW /	HIGH
OFF	SPEED PILOT
SWITCH	LAMP

The blower medium speed switch changes the blower speed to medium. This switch works only if the blower is already running at low or high speed.

The blower high speed switch changes the blower speed to high. This switch works only if the blower is already running at low or medium speed.

The pilot lamp lights up whenever the blower is on.

HEAT SENTRY™

Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above the cooking surface.

1)If blower is OFF - it turns blower ON to HIGH speed.

2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed. When the temperature level drops to normal, the blower will return to its original setting.

WARNING

The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.

LIGHT BULBS

This hood requires two 9-Watt fluorescent light bulbs.

ALWAYS SWITCH OFF THE ELECTRICITY

SUPPLY BEFORE CARRYING OUT ANY

OPERATIONS ON THE APPLIANCE.

To change bulbs:

1.Remove the light lens cover.

2.Remove the bulb by pulling sideward (Do not rotate). CAUTION: BULB MAY BE HOT!

3.Replace with a bulb of the same type.

- 4 -