INSTALL THE DUCTWORK
Ducted configuration only.
NOTE: To reduce the risk of fire, use only metal ductwork.
1.Decide where the ductwork will run between the hood and the outside.
2.A straight, short duct run will allow the hood to perform most efficiently.
3.Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible.
4.Install a roof or wall cap. Connect 6" round metal ductwork to cap and work back to- wards hood location. Use duct tape to seal the joints between ductwork sections.
ROOF CAP
| 6” ROUND |
| |
| DUCT |
| |
DECORATIVE | 6” ROUND |
| |
FLUE |
| ||
ELBOW | EAVE | ||
| |||
|
| ||
|
| VENT |
HOOD
24” TO 30” ABOVE
COOKING SURFACE
(See “Adjust Support Frame” section for mounting restrictions.)
INSTALL SUPPORT SYSTEM
1.At hood location, install 2 X 4 cross fram- ing between ceiling joists using dimensions shown.
2.Finish the ceiling surface. Be sure to mark the location of the ceiling joists and cross framing.
DRYWALL | CROSS FRAMING |
7” |
|
| CEILING |
| JOISTS |
WASHERS |
|
6.4mm |
|
MOUNTING |
|
SCREWS |
|
6x70mm |
|
| SUPPORT |
| FRAME |
TOP VIEW OF
SUPPORT FRAME
7”
7”
- 7 -