Mitsubishi Electronics WD-52825, WD-62825 manual Receiver Input Learn Screen, Receiver Learn Screen

A/V Receiver Input Learn Screen

Figure 8

NetCommand can now learn the remote control signals used to select each input on the A/V receiver.

1.Press ADJUST or on the TV remote to select the check box for each function to be learned.

2.Press ENTER and the function name will begin to flash to confirm the ready-to-learn status.

3.Point the A/V receiver’s remote control at the TV screen. Press the button on the remote control that corresponds to the selected function. A check mark will appear and the function name will stop flashing. This confirms the signal learned status.

4.To test the learned command, while the function is selected, press ENTER on the TV remote. The A/V receiver will perform the selected function. The A/V receiver needs to be turned on and the IR emitters properly placed for the test to be successful (see page 27 for IR emitter placement).

5.To customize the input names, press ADJUST to move to the Input Name text box and then press ADJUST or and ENTER to select each letter of the name. These names will appear on the Review screen as the A/V receiver’s input names.

6.To erase the learned input signal, highlight the check box for that input and press CANCEL.

7.Repeat for each connected input.

8.When the input selection signals have been learned

and the inputs named, press ADJUST to select Next> and move to the A/V receiver Learn screen.

A/V Receiver Learn Screen

Figure 9

1.Press ADJUST or on the TV remote to select the check box for each function to be learned.

2.Press ENTER and the function name will begin to flash to confirm the ready-to-learn status.

3.Press the button on the A/V receiver’s remote control that corresponds to the selected function, A check mark will appear and the function name will stop flashing. This confirms the signal learned status.

4.To test the learned command, press ENTER on the TV remote. The A/V receiver will perform the selected function. The A/V receiver needs to be turned on and the IR emitters properly placed for the test to be successful (see page 27 for IR emitter placement).

5.Repeat for each function to be learned.

6.To erase a learned function, highlight the check box for that function and press CANCEL.

7.When the function signals have been learned, press

ADJUST to select Next> and move to the Name screen.