Mitsubishi Electronics WD-62825 Cable Boxes and Satellite Receivers, Mitsubishi A/V Receivers

IMPORTANT

Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, the TV remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.

After entering the correct codes in each position of the remote control, use the slide switch to select which product will respond when an operational button is pressed. Only one of the below devices is allowed for each slide switch position.

TV position:

TV, NetCommand® Controlled Devices

Cable/DBS/DTV position:

Cable box

Satellite receiver

DTV receiver

VCR position:

VCR

DVD position:

DVD

LD Player

Audio position:

A/V receiver

Mitsubishi CD player

If you have a Mitsubishi A/V receiver, the audio position may be used in conjunction with select Mitsubishi CD players. Your audio position must be programmed to 010.

When your remote control has been programmed to operate another manufacturer’s product, the function performed on each layer can vary. The most common functions are:

VCR

•POWER

•CHANNEL up/down

•PLAY

•REC

•PAUSE

•STOP

•FF/FWD

•REW/REV

Mitsubishi VCRs will be compatible with some additional buttons

Cable Boxes and Satellite Receivers

•POWER

•CHANNEL up/down

•0-9 number buttons (on some models)

•ENTER (on some models)

•CANCEL (on some models)

•ADJUST up/down/ left/right (on some models)

•GUIDE (on some models)

A/V Receivers

•POWER

•VOLUME

•MUTE

Mitsubishi A/V Receivers

•Direct Input Selection buttons: numbers, SQV and QV (on some models)

Mitsubishi CD Players

(not all functions for all models)

•PLAY

•FF/FWD

•REW/REV

•PAUSE

•STOP

DVD and Laser Disc Players

(not all functions for all models)

•POWER

•MENU

•0-9 number buttons (on some models)

•PLAY

•STOP

•ARROW up/down/left/right (on some models)

•FF/FWD

•REW/REV

•PAUSE

•CANCEL (on some models)

•ENTER

•CHANNEL (on some models)