Mitsubishi Electronics WD-52825 Setting up Recordings, Recording Now, Time-Delayed Recording

Setting up Recordings

Figure 13

Through NetCommand, you can automatically start and stop recordings and send signals from one playback device to a recording device. Recordings can be made on recordable devices connected to the TV or to the internal TV Disc. The TV Disc is an IEEE 1394 hard disk drive, with 120 GB of memory and is available for CableCARD™, Ant 1, Ant 2, IEEE 1394 or tuning devices (cable boxes or satellite receivers) connected to inputs 1, 2, 3 when a PIP or POP is not displayed.

The TV can convert digital channels and IEEE 1394 device signals to analog signals that can be recorded on NetCommand compatible analog VHS and S-VHS VCRs.

You can schedule the recording to take place at a later time and program the recording duration for a minimum of 30 minutes and a maximum of 6 hours (in 30 minute increments). The default is 1 hour. During the recording, the TV can be powered Off. If the TV is powered On, it will be tuned to the source that is being recorded. The TV should remain on this source to ensure the recording continue without interruption.

Figure 13. Record to screen

Recording Now

Can be used when viewing Antenna 1 or 2, an IEEE 1394 device including TV Disc, or a non-recording traditional device.

To initiate recording now:

1.Press REC (record) on the TV remote.

2.Press DEVICE on the remote control to move to the Source Device section.

3.Press ADJUST , , or to select the source device you will record from. If a source is not displayed, it is not available as a recording source.

4.Press ENTER to confirm selection and return to the “Record to” section.

5.In the “Record to” section, review the destination device and duration. Use ADJUST or to change, if necessary.

6.Press a second time and the recording will start.

Time-Delayed Recording

1.Press REC (record) on the TV remote.

2.Press DEVICE on the remote control to move to the Source Device section.

3.Press ADJUST , , or to select the source device you will record from.

4.Press ENTER to confirm your source device selection and move to the Record to section.

5.Press ADJUST or to select the Record to device, duration time, start time (press ENTER after selecting hour, minutes and AM or PM to set the time) and day, using ADJUST or to change,. For devices that can select channels, select the channel.

6.Select Add and press ENTER to add the recording to the record list. If your selection is successful, a confirmation message will be displayed. If you pick overlapping times, day(s), or destination devices, you will see a message stating there is a conflict.

7.To exit, press HOME on the TV remote after all recordings have been added.