Eiki EIP-3000N owner manual 1Setting a Password

Setting up the Projector Network Environment (“Network” menu)

Menu operation n Page 40

Pict.			SCR	PRJ		Network	Help
Password						Disable
DHCP Client						On
TCP/IP
		MAC Address		0 0 : 0 B : 2 C : 0 1 : 0 0 : 0 0
		Projector		EIP-3000N
	SEL./ADJ.				ENTER		END

1Setting a Password

If you do not want others to change the setting for the “Network” menu, set a password.

aSetting a Password

1Select “Password”, then press hENTER or Q.

•The screen for entering the password appears.

	Network
Setting the Password
Old Password		– – – –
New Password		–	–	–	–
Reconfirm		– – – –

2	Press P or R to set the first digit
	in “New Password”, then press Q.
3	Enter the remaining 3 digits, then
	press hENTER.
	• To return to the previous digit, press O.
4	Enter the same password in “Re-
	confirm”, then press hENTER.

• The status for “Password” changes to “Enable”.

Note

•Once after the password is set, you must en- ter the password to change the “Network” menu settings.

aChanging the Password

1Select “Password”, then press hENTER or Q.

•The screen for entering the password appears.

2	Enter the password in “Old Pass-
	word” using P, R, Q and O, then
	press hENTER.
3	Enter the password in “New Pass-
	word” using P, R, Q and O, then
	press hENTER.
4	Enter the same password again in
	“Reconfirm” using P, R, Qand O,

then press hENTER.

Note

•If you do not need the password protection

for the “Network” menu settings anymore, press hENTER without entering new pass- word in steps 3 and 4.

•To cancel the password settings, press l

RETURN.

If you forget the password

If you forget the password, perform the fol- lowing procedure to delete it, then set a new password.

On the projector, press

o→p→o→p→o→p→r.

Note

•If pENTER is held down for more than 5 seconds, the operation buttons on the pro- jector will be locked. (See page 48.)

•You cannot use the buttons on the remote control to delete the password.

49