Eiki EIP-3000N owner manual Input 1 Component

Troubleshooting (Continued)

Problem		Check	Page
Picture is green on	•	Change the input signal type setting.	51
INPUT 1 (COMPONENT)/	•	When you cannot select an input signal type, select “Color is faded	42, 51
INPUT 2 (COMPONENT).		or poor” in the “Help” menu, after selecting an item other than
		“sRGB” in “Picture Mode”, and then select an input signal type.
Picture is pink (no green)
on INPUT 1 (RGB)/INPUT
2 (RGB).
Picture is too bright and	•	Image adjustments are incorrectly set.	43
whitish.
The cooling fan becomes	•	When temperature inside the projector increases, the cooling fan	–
noisy.		runs faster.
The lamp does not light	•	The lamp indicator is illuminating in red.
up even after the		Replace the lamp.
projector turns on.			53, 56
The lamp suddenly turns
off during projection.
The image sometimes	•	Cables incorrectly connected to the projector or the connected	23–27
flickers.		equipment works improperly.
	•	Select “Vertical stripes or flickering image appear” in the “Help”	51
		menu and make the necessary adjustments.
	•	If this happens frequently, replace the lamp.	56
The lamp needs much	•	The lamp will eventually need to be changed.	56
time to turn on.		While the remaining lamp life draws to a close, replace the lamp.
Picture is dark.

This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.

60