Philips DCR 2021 First installation settings, Channel scan, Set your TV display format

Page 16

5 First installation

Your receiver is connected to the cable wall socket,TV set and other equipment according to the diagrams in chapter Quick installation.

1Switch on your TV set and select a channel.

2 Plug your receiver into the mains.Wait for	EN
approximately 20 seconds for the welcome screen
to appear.

3Wait for a few seconds for the First installation screen to appear.

5.1 First installation settings

4Set your favourite Language setting.

5Set your TV display format.

6Press OK to start scanning for channels.

5.2 Channel scan

During the scanning process, the following information is reported on screen:

•number of TV and radio channels detected

•scanning progress, indicated as a percentage

•strength of the signal and the quality of reception.

Channel scan may take up to twenty minutes. If you press

EXIT during the scanning process, you interrupt the

scanning. In this case, none of the channels found are stored.

When scanning has been successfully completed, a completion message is displayed.

7Press OK; a new screen appears indicating that a search for new software is in progress.

8Press EXIT to stop searching and tune the receiver to the first channel in the main TV list.

Alternatively, wait for software detection, and then proceed as described in paragraph 10.5.5.2.

63

Image 16

Contents Benutzerhandbuch Foreword Dear CustomerQuick installation Press OK to start scanning for channels Meaning of symbols Safety instructions For future referenceContents Timer Manager SettingsAdvanced settings Restoring factory settingsProduct description Front panelRear panel Inserting your Smart Card Insert the smartcard with the golden chip facing upRemote control RED, GREEN,YELLOW BlueConnecting your Digital-receiver Connecting to a TV and VCR both fitted with Scart socketsConnecting to your audio equipment analogue or digital Analogue Connection aConnecting of a video projector to watch digital TV First installation First installation settingsChannel scan Set your TV display formatSearch failure Before starting a new scanUsing Low Power mode Your cable receiver is in standby modeDay-to-day operation Digital radioUsing number keys Using P+/P- keysUsing channel lists PIN codeVolume control / + BannerTo modify your PIN code, refer to paragraph PIN-Code Change To close the banner, press Info a third timeCurrent programme options While watching digital TV or listening to digital radioRecording timers Set a timer from the EPGSetting a timer via the Timer Manager Deleting an active timerSwitching to analogue TV Premiere features Premiere MultifeedMenu Tree Menu treeChanging settings Cancelling/storing changesMenu navigation BasicsPremiere Service Menu PIN-Code ChangeSmartcard SystemDolby Digital DisplayWake-up channel Setting your receiver Timer ManagerTo delete an existing timer To set a new timer or edit an existing timerList Organization Channel ManagerMonday to Friday , or Monday to Saturday List Editing Scroll to the channel you want to move using the ty keysChannel List Main TV, which is the only editable list Channel Pool SettingsDisplay options To enable Parental Lock To modify your receiver passwordMust not be used as a password For ParentsAdvanced settings TV SettingsSystem Settings Enter your new password again to confirm Press ExitTime Settings Factory settingsYou can also access this screen via the Premiere menu Decoder StatusYour receiver later, and then press OK to confirm Channel SearchSoon as you set your receiver to standby Other settings Restoring factory settingsChanging the remote control configuration 11.3 VCR/DVD Recorder ControlEXT Digital-Receiver and VCR or DVD settings Recording with the VCR/DVD Recorder Control featurePage Troubleshooting Problem Possible cause ActionChange the TV Scart Output Technical specifications Video decoding3111 176