Philips DCR 2021 user manual Channel Search, Your receiver later, and then press OK to confirm

Page 36

In case software is available, you are offered three options:

-	Press the green colour key to choose to upgrade
	your receiver immediately, and then press OK to
	launch new software installation.
-	Or press the yellow colour key to choose to upgrade
	your receiver later, and then press OK to confirm
	your choice. New software installation takes place as
	soon as you set your receiver to standby.
-	Or press the red colour key to refuse to upgrade your	EN
	receiver and return to the Decoder status sub menu.	EN

After successful software installation, a confirmation message is displayed. In case of installation failure, a failure message is displayed, indicating that a new installation attempt will take place as soon as you set your receiver to standby. In both cases, press OK to exit the upgrade process.

You can also launch a search for new software from the

screen described above using the red colour key.

10.6 Channel Search

This item is used to search for new channels.

It is recommended not to change the predefined settings:

•Start frequency: 306 MHz

•Stop frequency: 442 MHz

•Constellation:Auto

•Band width: 8000 KHz

Press OK to start searching for new channels.

During the scanning process, the following information is reported on screen:

•the number of TV and Radio channels found,

•the scanning progress, indicated as a percentage,

•the strength of the signal and the quality of reception.

If you press EXIT during the scanning process, you interrupt the scanning. In this case, none of the channels found are stored.

When scanning is successfully completed, a completion message is displayed as well as the number of channels detected.

Press OK to tune the receiver according to the Wake- up channel setting.

83

Image 36

Contents Benutzerhandbuch Foreword Dear CustomerQuick installation Press OK to start scanning for channels Meaning of symbols Safety instructions For future referenceContents Timer Manager SettingsAdvanced settings Restoring factory settingsProduct description Front panelRear panel Inserting your Smart Card Insert the smartcard with the golden chip facing upRemote control RED, GREEN,YELLOW BlueConnecting your Digital-receiver Connecting to a TV and VCR both fitted with Scart socketsConnecting to your audio equipment analogue or digital Analogue Connection aConnecting of a video projector to watch digital TV First installation First installation settingsChannel scan Set your TV display formatSearch failure Before starting a new scanUsing Low Power mode Your cable receiver is in standby modeDay-to-day operation Digital radioUsing number keys Using P+/P- keysUsing channel lists PIN codeVolume control / + BannerTo modify your PIN code, refer to paragraph PIN-Code Change To close the banner, press Info a third timeCurrent programme options While watching digital TV or listening to digital radioRecording timers Set a timer from the EPGSetting a timer via the Timer Manager Deleting an active timerSwitching to analogue TV Premiere features Premiere MultifeedMenu Tree Menu treeChanging settings Cancelling/storing changesMenu navigation BasicsPremiere Service Menu PIN-Code ChangeSmartcard SystemDisplay Dolby DigitalWake-up channel Setting your receiver Timer ManagerTo delete an existing timer To set a new timer or edit an existing timerChannel Manager List OrganizationMonday to Friday , or Monday to Saturday Scroll to the channel you want to move using the ty keys List EditingChannel List Main TV, which is the only editable list Settings Channel PoolDisplay options To enable Parental Lock To modify your receiver password Must not be used as a password For ParentsAdvanced settings TV SettingsSystem Settings Enter your new password again to confirm Press ExitTime Settings Factory settingsYou can also access this screen via the Premiere menu Decoder StatusChannel Search Your receiver later, and then press OK to confirmSoon as you set your receiver to standby Other settings Restoring factory settingsChanging the remote control configuration 11.3 VCR/DVD Recorder ControlEXT Digital-Receiver and VCR or DVD settings Recording with the VCR/DVD Recorder Control featurePage Troubleshooting Problem Possible cause ActionChange the TV Scart Output Technical specifications Video decoding3111 176