CYCLING CTS KIT
4.0 Reflectors and Flag Assembly
Attach the reflector to the spokes.
Insert orange clip into reflector and over the spoke. With a slot screwdriver, turn the clip until reflector is tight and unable to shift.
Attach the red reflector to the left grommet on the rear of the back storage bag.
PLASTIC CAP
LOCATION FOR
FLASHING CLIP
ON LIGHT
Insert flag into hole located in the plastic cap on the upper left rear side of frame. Slide flag down into hole until flag touches the bottom of the tube.
Note: For additional visibility you may wish to purchase a battery powered
WARNING:
Read and understand all of the warnings otherwise injury or death to you or to your passengers could result:
–Always use safety flag.
–Do not operate the bicycle trailer without reading and understanding this manual.
–Use extreme caution while trailering, never exceed 25 km/h and slow down to less than 10 km/h around corners and on rough roads.
–Avoid all obstacles as carriers can tip over causing serious injuries to the passenger and cyclist.
–Passenger must always use seat belts and wear an approved helmet.
–Child must be old enough to wear a helmet and to sit upright unattended. Consult pediatrician if child is less that one year old.
–Child’s head, including helmet, must not protrude above upper frame.
–Never leave child unattended in carrier.
–Do not exceed the maximum capacity for a single carrier of 75lb (34kg) and for a double carrier of 100 lb (45kg) including children and cargo.
–Cyclist must be an experienced, strong rider.
13