19
Attachment Of Infant Car Seat To Base:
Removal Of Infant Car Seat From Base:
1Pull car seat release handle 1 and lift car seat from base 2 (fig. a).
Attaching Infant Car Seat To Base:
1Verify that there are no objects on top of base or between base and infant car seat that will prevent proper latching of car seat.
2
Car Seat 
Release (fig. a) 1 Handle
- Verify lower anchor belt is routed or stored properly.
2 With child facing the rear of the vehicle, lower car seat into base and push down on car seat to lock car seat into base (fig. b).
3 Test to be sure car seat is locked in base. Lift on car seat at top of seat back 1 (fig. c) and at child’s feet 2 .
2 
1
(fig. b) | (fig. c) |
4Carry handle should be kept in the carry position (see “Carry Handle Operation”
section).
5 Adjust recline using recline indicator on the side of car seat. Line on recline indicator MUST be in green striped zone (fig. d).
If line is not in green striped zone, adjust base using the recline foot (see “Base Adjustment” section), and recheck recline of car seat. Repeat until recline indicator is in green striped zone.
If base can not be adjusted to locate the line in the green |
| (fig. d) | |
striped zone: | Green |
| |
|
|
| |
1. | Try a different seating position. | Striped |
|
2. | Do not use this infant car seat. | Zone | Recline |
NOTE: Vehicle must be parked on flat, level surface during this installation. | Indicator | ||
Line | |||
6Verify that LATCH belt or vehicle seat belt is still tightly adjusted around base.
20