Combi 8045 instruction manual Installation with Lap Belt Only, Green Striped Zone

Page 17

31

Securing Infant Car Seat Without Base:

WARNING DEATH or SERIOUS INJURY can occur

Not all vehicle seat belts can be used with a car seat. Read vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.

Installation with Lap Belt Only:

1

2

3

4

5

6

Refer to vehicle owner’s manual to identify the seating locations which can be used with a car seat. Check for specific instructions for car seat use.

After selecting a seating location, if vehicle seat back is adjustable, adjust vehicle seat back into most upright position.

Place car seat rear-facing on vehicle seat.

Thread vehicle lap belt through vehicle lap belt guides on car seat (fig. a) and buckle

vehicle belt. Be sure vehicle lap belt is not twisted.

(fig. a)

Press down firmly on car seat to compress vehicle seat cushion while tightening vehicle lap belt (fig. b).

Adjust recline using the recline indicator on the side of car seat (fig. c). Line on recline indicator must be in green striped zone.

If line is not in green striped zone, place a tightly rolled up

 

 

towel, blanket or firm foam (pool noodle) under end of car

 

 

seat contacting vehicle seat back.

(fig. b)

 

If car seat can not be adjusted to locate the line in the green

 

 

striped zone:

 

 

1. Try a different seating position.

 

 

2. Do not use this infant car seat.

Green Striped

 

NOTE: Vehicle must be parked on horizontal surface

 

Zone

(fig. c)

during this installation.

 

 

Recline

 

 

Indicator

 

32

Image 17
Contents Combi Connection Infant Car Seat Page Table of Contents HandleCarry Infant CAR Seat Connection Infant Car Seat PartsInfants With Special Needs Height and Weight LimitsUse Recommendations Securing Infant In Car Seat Fig. c Securing infant in car seatSelecting a Vehicle Seating Location Options For Securing a Car Seat Latch SystemLatch System On This Car Seat Latch System On VehiclesInstallation of Infant Car Seat in Vehicle Removal Of Infant Car Seat From Base Zone Recline Indicator LineAttaching Infant Car Seat To Base Car Seat Release fig. a 1 HandleSecuring Base With Latch System Latch Lower Anchor ConnectorsStriped Zone GreenAnchor Connector Removal Of Base Installed With LatchStorage Of Lower Anchorage Belt And Lower Anchor Connectors Securing Base With Vehicle Seat Belt Fig. b Recline IndicatorLap Belt Center Section Lap BeltGreen Striped Zone Installation with Lap Belt OnlyFig. d Shoulder Belt Guide Installation with Lap And Shoulder BeltsRemoval Of Infant Car Seat From Vehicle Stroller or Travel System UseHarness Use and Adjustment Operation and AdjustmentHarness Adjuster Strap Changing Use Position and Harness LengthTab Adjuster Under CoverRod Recline Adjustment Handle Base AdjustmentInfant Insert Infant Insert Pillow Mommy’s Lap Infant InsertHead Pillow Canopy Vehicle Seat Belt SystemsTop Canopy Insert bottom canopy lever into bottom canopy bracketBelts Forward of Seat Bight Lap Belts Manually AdjustableLap Belts With Retractor Bight Belt Forward BuckleFig. e Front Door Lap or Shoulder Belt Mounted on Front Door fig. fLocking Clip stored in pouch on back of car seat Additional Information Care and CleaningRegistration Information Re-use After a CrashLimited Warranty