Combi 8045 instruction manual Installation with Lap And Shoulder Belts, Fig. d Shoulder Belt Guide

Page 18

33

7Check for secure installation. Pull front to back and left to right to check for secure installation (fig. d). Vehicle lap belt MUST stay tight.

If vehicle lap belt does not stay tight, see “Installation with Lap/Shoulder Belts” below.

8Recheck car seat recline. Verify line is in green striped zone of recline indicator.

9Carry handle should be kept in the carry position, (see “Carry Handle Operation” section).

Installation with Lap And Shoulder Belts:

• When using vehicle lap and shoulder belts, shoulder belt may be used for additional support. Place shoulder belt around

back of Combi Connection™ (fig. e) and through the vehicle shoulder belt guide on back of car seat shell (fig. f). If shoulder belt is too short to go around back of Combi Connection™, position shoulder belt against vehicle seat back (fig. g). Do not route shoulder belt through lap belt

guides on either side of car seat. (fig. e)

• Lap/shoulder belt with free sliding latch plate:

- Pull out on latch plate (fig. h). If belt slides freely through latch plate, a locking clip must be used as described in “Locking Clip” section.

- Some combination lap/shoulder belts with free sliding latch plates may be converted into an “automatic locking mode” that will allow use without a locking clip. See vehicle owner’s manual and label on vehicle belts for instructions.

34

(fig. g)

(fig. d)

Shoulder

Belt Guide

(fig. f)

(fig. h)

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Combi Connection Infant Car Seat Page Table of Contents Connection Infant Car Seat Parts HandleCarry Infant CAR SeatHeight and Weight Limits Use RecommendationsInfants With Special Needs Securing Infant In Car Seat Securing infant in car seat Fig. cSelecting a Vehicle Seating Location Latch System On This Car Seat Latch SystemOptions For Securing a Car Seat Latch System On VehiclesInstallation of Infant Car Seat in Vehicle Attaching Infant Car Seat To Base Zone Recline Indicator LineRemoval Of Infant Car Seat From Base Car Seat Release fig. a 1 HandleLatch Lower Anchor Connectors Securing Base With Latch SystemGreen Striped ZoneRemoval Of Base Installed With Latch Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsAnchor Connector Fig. b Recline Indicator Securing Base With Vehicle Seat BeltCenter Section Lap Belt Lap BeltInstallation with Lap Belt Only Green Striped ZoneInstallation with Lap And Shoulder Belts Fig. d Shoulder Belt GuideStroller or Travel System Use Removal Of Infant Car Seat From VehicleHarness Adjuster Strap Operation and AdjustmentHarness Use and Adjustment Changing Use Position and Harness LengthAdjuster Under Cover RodTab Base Adjustment Recline Adjustment HandleMommy’s Lap Infant Insert Head PillowInfant Insert Infant Insert Pillow Top Canopy Vehicle Seat Belt SystemsCanopy Insert bottom canopy lever into bottom canopy bracketLap Belts With Retractor Lap Belts Manually AdjustableBelts Forward of Seat Bight Bight Belt Forward BuckleLap or Shoulder Belt Mounted on Front Door fig. f Fig. e Front DoorLocking Clip stored in pouch on back of car seat Care and Cleaning Additional InformationRe-use After a Crash Registration InformationLimited Warranty
Top Page Image Contents