Combi 8045 instruction manual Securing Base With Vehicle Seat Belt, Fig. b Recline Indicator

Page 15

Green

Striped Zone

27

Securing Base With Vehicle Seat Belt:

WARNING DEATH or SERIOUS INJURY can occur

•Not all vehicle seat belts can be used with a car seat. Read vehicle owner’s manual and “Vehicle Seat Belts” section in this manual.

1

2

3

Refer to vehicle owner’s manual to identify the seating locations which can be used with a car seat. Check for specific instructions for car seat use.

After selecting a seating location, if vehicle seat back is adjustable, adjust vehicle seat back into most upright position.

Place base with car seat attached rear-facing on vehicle seat with blue lap belt guides toward vehicle seat back (fig. a).

(fig. a)

4Adjust recline of car seat. Line inside recline indicator on side of car seat MUST be in green striped zone (fig. b). If line is not in green striped zone, adjust base (see “Base Adjustment” section), and recheck recline of car seat. Repeat until recline indicator is in the green striped zone.

If base can not be adjusted to locate the line in the green striped zone:

1. If necessary, place tightly rolled towel, pool noodle, or firm object under recline foot to level car seat.

2. Try a different seating position.

3. Do not use this infant car seat.

NOTE: Vehicle must be parked on horizontal surface during this installation.

(fig. b)

Recline

Indicator

5Remove car seat from base.

28

Image 15

Contents Combi Connection Infant Car Seat Page Table of Contents HandleCarry Infant CAR Seat Connection Infant Car Seat PartsHeight and Weight Limits Use RecommendationsInfants With Special Needs Securing Infant In Car Seat Fig. c Securing infant in car seatSelecting a Vehicle Seating Location Latch System On Vehicles Latch SystemOptions For Securing a Car Seat Latch System On This Car SeatInstallation of Infant Car Seat in Vehicle Car Seat Release fig. a 1 Handle Zone Recline Indicator LineRemoval Of Infant Car Seat From Base Attaching Infant Car Seat To BaseSecuring Base With Latch System Latch Lower Anchor ConnectorsStriped Zone GreenRemoval Of Base Installed With Latch Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsAnchor Connector Securing Base With Vehicle Seat Belt Fig. b Recline IndicatorLap Belt Center Section Lap BeltGreen Striped Zone Installation with Lap Belt OnlyFig. d Shoulder Belt Guide Installation with Lap And Shoulder BeltsRemoval Of Infant Car Seat From Vehicle Stroller or Travel System UseChanging Use Position and Harness Length Operation and AdjustmentHarness Use and Adjustment Harness Adjuster StrapAdjuster Under Cover RodTab Recline Adjustment Handle Base AdjustmentMommy’s Lap Infant Insert Head PillowInfant Insert Infant Insert Pillow Insert bottom canopy lever into bottom canopy bracket Vehicle Seat Belt SystemsCanopy Top CanopyBight Belt Forward Buckle Lap Belts Manually AdjustableBelts Forward of Seat Bight Lap Belts With RetractorFig. e Front Door Lap or Shoulder Belt Mounted on Front Door fig. fLocking Clip stored in pouch on back of car seat Additional Information Care and CleaningRegistration Information Re-use After a CrashLimited Warranty