Combi 8045 instruction manual Locking Clip stored in pouch on back of car seat, Fig. a

Page 27

51

Section 12 - Vehicle Seat Belt Systems

Locking Clip (stored in pouch on back of car seat):

You MUST use locking clip provided with this car seat with a vehicle belt that slides freely through the latch plate or if the lap portion of the lap/shoulder belt cannot be tightly secured.

WARNING DEATH or SERIOUS INJURY can occur

Avoid serious injury or death:

•Failure to use locking clip where required will result in car seat not being securely held in place.

•Remove locking clip from vehicle seat belts when not being used with car seat.

•DO NOT use locking clip as a vehicle seat belt shortener.

1Install car seat or base rear-facing on vehicle seat and tighten vehicle seat belts.

2While holding vehicle seat belts to together at latch plate (fig. a), unbuckle belt.

3 Slide vehicle belt out of vehicle lap belt guide on the side of the seat or base which the buckle is on.

4 Slide locking clip onto vehicle seat belts approximately 1/2 inch (1 cm) away from latch plate (fig. b).

5 Slide vehicle belt back into vehicle lap belt guide.

- Check to be sure vehicle lap belt is still correctly routed throughout entire belt path.

6

7

Re-buckle vehicle seat belt.

(fig. a)

Test installation to see if car seat or base is secure.

If not secure, additional vehicle seat belt tightening may be necessary.

 

• Unbuckle vehicle seat belt.

 

• Hold vehicle seat belts together and remove locking clip.

 

• Shorten length of vehicle lap belt portion slightly by pulling vehicle lap belt through

 

latch plate.

 

• Re-attach locking clip.

1/2 inch (1 cm)

• Buckle vehicle seat belt.

 

HINT: Press car seat or base down into vehicle seat cushion to help buckle vehicle seat belt.

Test installation to see if car seat or base is secure, if not secure, repeat above steps until

(fig. b)

car seat is secure.

52

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Combi Connection Infant Car Seat Page Table of Contents HandleCarry Infant CAR Seat Connection Infant Car Seat PartsHeight and Weight Limits Use RecommendationsInfants With Special Needs Securing Infant In Car Seat Fig. c Securing infant in car seatSelecting a Vehicle Seating Location Latch System On Vehicles Latch SystemOptions For Securing a Car Seat Latch System On This Car SeatInstallation of Infant Car Seat in Vehicle Car Seat Release fig. a 1 Handle Zone Recline Indicator LineRemoval Of Infant Car Seat From Base Attaching Infant Car Seat To BaseSecuring Base With Latch System Latch Lower Anchor ConnectorsStriped Zone GreenRemoval Of Base Installed With Latch Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsAnchor Connector Securing Base With Vehicle Seat Belt Fig. b Recline IndicatorLap Belt Center Section Lap BeltGreen Striped Zone Installation with Lap Belt OnlyFig. d Shoulder Belt Guide Installation with Lap And Shoulder BeltsRemoval Of Infant Car Seat From Vehicle Stroller or Travel System UseChanging Use Position and Harness Length Operation and AdjustmentHarness Use and Adjustment Harness Adjuster StrapAdjuster Under Cover RodTab Recline Adjustment Handle Base AdjustmentMommy’s Lap Infant Insert Head PillowInfant Insert Infant Insert Pillow Insert bottom canopy lever into bottom canopy bracket Vehicle Seat Belt SystemsCanopy Top CanopyBight Belt Forward Buckle Lap Belts Manually AdjustableBelts Forward of Seat Bight Lap Belts With RetractorFig. e Front Door Lap or Shoulder Belt Mounted on Front Door fig. fLocking Clip stored in pouch on back of car seat Additional Information Care and CleaningRegistration Information Re-use After a CrashLimited Warranty
Top Page Image Contents