Combi 8045 instruction manual Removal Of Base Installed With Latch, Anchor Connector

Page 14

25

13Attach car seat to base.

14Recheck recline of car seat. Adjust if necessary (see step 8).

Removal Of Base Installed With LATCH:

1Loosen lower anchor belt:

2

3

-While pressing down in center of base to reduce tension on lower anchorage belt, push adjuster release button and loosen belt.

Press and hold the connector retainer spring 1 .

Push connector in, then rotate connector 2 , and pull out 3 to unhook from the vehicle anchorage (fig. a). If the connector can’t be rotated, push in and lift the connector to unhook from the vehicle anchorage.

Repeat to remove connector on opposite side.

3

2

1

(fig. a)

Storage Of Lower Anchorage Belt And Lower Anchor Connectors:

When not using the LATCH System, store the anchor belt adjuster and lower anchor connectors by placing the connectors over the pins inside base and folding belts into the recessed areas of the base (fig. a).

- Belts and lower anchor connectors MUST be properly stored in base to allow Pins secure attachment of car seat to base.

LATCH Lower	(fig. a)
Anchor Connector

26

Image 14

Contents Combi Connection Infant Car Seat Page Table of Contents Connection Infant Car Seat Parts HandleCarry Infant CAR SeatInfants With Special Needs Height and Weight LimitsUse Recommendations Securing Infant In Car Seat Securing infant in car seat Fig. cSelecting a Vehicle Seating Location Latch System On This Car Seat Latch SystemOptions For Securing a Car Seat Latch System On VehiclesInstallation of Infant Car Seat in Vehicle Attaching Infant Car Seat To Base Zone Recline Indicator LineRemoval Of Infant Car Seat From Base Car Seat Release fig. a 1 HandleLatch Lower Anchor Connectors Securing Base With Latch SystemGreen Striped ZoneAnchor Connector Removal Of Base Installed With LatchStorage Of Lower Anchorage Belt And Lower Anchor Connectors Fig. b Recline Indicator Securing Base With Vehicle Seat BeltCenter Section Lap Belt Lap BeltInstallation with Lap Belt Only Green Striped ZoneInstallation with Lap And Shoulder Belts Fig. d Shoulder Belt GuideStroller or Travel System Use Removal Of Infant Car Seat From VehicleHarness Adjuster Strap Operation and AdjustmentHarness Use and Adjustment Changing Use Position and Harness LengthTab Adjuster Under CoverRod Base Adjustment Recline Adjustment HandleInfant Insert Infant Insert Pillow Mommy’s Lap Infant InsertHead Pillow Top Canopy Vehicle Seat Belt SystemsCanopy Insert bottom canopy lever into bottom canopy bracketLap Belts With Retractor Lap Belts Manually AdjustableBelts Forward of Seat Bight Bight Belt Forward BuckleLap or Shoulder Belt Mounted on Front Door fig. f Fig. e Front DoorLocking Clip stored in pouch on back of car seat Care and Cleaning Additional InformationRe-use After a Crash Registration InformationLimited Warranty