Combi 8045 instruction manual Securing Base With Latch System, Latch Lower Anchor Connectors

Page 12

21

Securing Base With LATCH System:

WARNING DEATH or SERIOUS INJURY can occur

•Only use the car seat LATCH System in vehicle seating locations recommended by the vehicle manufacturer for use with LATCH and that have an anchor spacing of 280 mm (11 inches).

•LATCH connectors must be secured to the vehicle LATCH anchorages only. Connection to other vehicle components could result in the anchor tearing free in a crash.

•Never attach more than one anchor connector to a vehicle lower anchorage unless recommended by the vehicle owner’s manual for that vehicle.

1 Refer to vehicle owner’s manual to identify the seating locations with LATCH System. Select the seating location to be used and locate the vehicle lower anchorages at the seat bight.

A LATCH Anchorage System with 280 mm (11 inch) spacing may not be available in your vehicle in the rear center seating position. If use of the rear center position is preferred, use the vehicle seat belt to secure the car seat. See “Securing Base With Vehicle Seat Belt” section.

2

3

4

5

If vehicle seat back is adjustable, adjust vehicle seat back into most upright position.

Remove car seat from base.

Lift the LATCH lower anchor connectors out of the base (fig. a).

Lengthen lower anchor belt. While pressing adjuster release button, pull belt to extend the length of lower anchor belt (fig. b).

LATCH Lower

Anchor Connectors

(fig. a)

6

7

Place lower anchor belt over side of base and into belt slot in vehicle lap belt guide with the belt adjuster slide buttons facing away from the car seat (fig. c). If the adjuster is not in that position, turn the belt and adjuster over.

Repeat for opposite side.

Lower

 

Anchor

Check that the belts are not twisted.

Belt

Pull

Adjuster

Release

Button

Vehicle Lap

Belt Slot

22(fig. b)

(fig. c)

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Combi Connection Infant Car Seat Page Table of Contents Connection Infant Car Seat Parts HandleCarry Infant CAR SeatHeight and Weight Limits Use RecommendationsInfants With Special Needs Securing Infant In Car Seat Securing infant in car seat Fig. cSelecting a Vehicle Seating Location Latch System Options For Securing a Car SeatLatch System On This Car Seat Latch System On VehiclesInstallation of Infant Car Seat in Vehicle Zone Recline Indicator Line Removal Of Infant Car Seat From BaseAttaching Infant Car Seat To Base Car Seat Release fig. a 1 HandleLatch Lower Anchor Connectors Securing Base With Latch SystemGreen Striped ZoneRemoval Of Base Installed With Latch Storage Of Lower Anchorage Belt And Lower Anchor ConnectorsAnchor Connector Fig. b Recline Indicator Securing Base With Vehicle Seat BeltCenter Section Lap Belt Lap BeltInstallation with Lap Belt Only Green Striped ZoneInstallation with Lap And Shoulder Belts Fig. d Shoulder Belt GuideStroller or Travel System Use Removal Of Infant Car Seat From VehicleOperation and Adjustment Harness Use and AdjustmentHarness Adjuster Strap Changing Use Position and Harness LengthAdjuster Under Cover RodTab Base Adjustment Recline Adjustment HandleMommy’s Lap Infant Insert Head PillowInfant Insert Infant Insert Pillow Vehicle Seat Belt Systems CanopyTop Canopy Insert bottom canopy lever into bottom canopy bracketLap Belts Manually Adjustable Belts Forward of Seat BightLap Belts With Retractor Bight Belt Forward BuckleLap or Shoulder Belt Mounted on Front Door fig. f Fig. e Front DoorLocking Clip stored in pouch on back of car seat Care and Cleaning Additional InformationRe-use After a Crash Registration InformationLimited Warranty
Top Page Image Contents