Combi 8045 Operation and Adjustment, Harness Use and Adjustment, Harness Adjuster Strap, Loops

Page 20

37

Section 11 - Operation and Adjustment

Harness Use and Adjustment

Harness Strap Adjustment:

•To tighten: Pull front adjuster strap (fig. a).

•To loosen: Insert finger under adjuster cover on pad, press harness adjuster lever, and pull harness straps out.

•If the harness cannot be adjusted to properly fit child, (see “Changing Harness Length And Use Position” section).

Chest Clip Operation:

Harness

Adjuster

Strap

(fig. a)

Harness

Adjuster

Lever

(Under

Adjuster

Cover)

1

•To open: Press tabs 1 and pull apart 2 (fig. b).

•To close: Snap halves together. Make sure chest clip is locked by pulling out.

Shoulder Strap Covers: Either “Folding” or “Tube” style covers are provided

Folding Style Covers:

Open folded shoulder strap cover, place over shoulder belt above chest clip with folded side toward child, and close shoulder belt cover (fig c.)

Tube Style Covers:

Unhook harness and pull out through seat back, see “Changing Shoulder Harness Slot Position” section. Slide shoulder belt up through strap cover, rethread harness straps through seat back, and re-attach harness to metal harness plate.

2 2

1

(fig. b)

(fig. c)

Changing Use Position and Harness Length

WARNING

•Shoulder belts MUST be through belt slots in infant insert.

•Shoulder harness MUST snugly adjust around infant.

•Shoulder harness straps MUST be through slots at or just below shoulders.

Each shoulder harness strap has two harness adjustment loops, 1 and 2 , to adjust harness fit as the infant grows. 38

 

1

Shoulder

2

Harness

 

Loops

(fig. a)

 

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Combi Connection Infant Car Seat Page Table of Contents Connection Infant Car Seat Parts HandleCarry Infant CAR SeatInfants With Special Needs Height and Weight LimitsUse Recommendations Securing Infant In Car Seat Securing infant in car seat Fig. cSelecting a Vehicle Seating Location Latch System Options For Securing a Car SeatLatch System On This Car Seat Latch System On VehiclesInstallation of Infant Car Seat in Vehicle Zone Recline Indicator Line Removal Of Infant Car Seat From BaseAttaching Infant Car Seat To Base Car Seat Release fig. a 1 HandleLatch Lower Anchor Connectors Securing Base With Latch SystemGreen Striped ZoneAnchor Connector Removal Of Base Installed With LatchStorage Of Lower Anchorage Belt And Lower Anchor Connectors Fig. b Recline Indicator Securing Base With Vehicle Seat BeltCenter Section Lap Belt Lap BeltInstallation with Lap Belt Only Green Striped ZoneInstallation with Lap And Shoulder Belts Fig. d Shoulder Belt GuideStroller or Travel System Use Removal Of Infant Car Seat From VehicleOperation and Adjustment Harness Use and AdjustmentHarness Adjuster Strap Changing Use Position and Harness LengthTab Adjuster Under CoverRod Base Adjustment Recline Adjustment HandleInfant Insert Infant Insert Pillow Mommy’s Lap Infant InsertHead Pillow Vehicle Seat Belt Systems CanopyTop Canopy Insert bottom canopy lever into bottom canopy bracketLap Belts Manually Adjustable Belts Forward of Seat BightLap Belts With Retractor Bight Belt Forward BuckleLap or Shoulder Belt Mounted on Front Door fig. f Fig. e Front DoorLocking Clip stored in pouch on back of car seat Care and Cleaning Additional InformationRe-use After a Crash Registration InformationLimited Warranty
Top Page Image Contents