Combi 8045 instruction manual Adjuster Under Cover, Rod, Tab

Shoulder

Harness

Loop

39

Changing Shoulder Harness Length:

1.Buckle harness and chest clip.

2.From front of car seat, unsnap harness adjuster strap from front of car seat pad, loosen harness straps by pressing harness adjuster lever, 3 , and pulling harness straps out, 4 (fig. d).

3.From back of car seat, remove both harness adjustment loops from metal harness plate (fig. e).

4.Route shoulder harness straps between plastic

seat and metal rod.

To lengthen shoulder harness:

- Re-attach metal harness plate in lower adjustment loops 2

on shoulder harness straps (fig. f). To shorten shoulder harness:

-Re-attach metal harness plate in upper adjustment loops 1

on shoulder harness straps.

5. Check that loops are completely in slots Tab of metal harness plate, and under tabs

on both sides (fig. f).

	4
Shoulder	3
Harness
Adjuster
(Under
Adjuster
Cover )	(fig. d)
Metal
Rod
	2
	1
(fig. e)	(fig. f)
Metal
Harness Plate

Changing Shoulder Harness Slot Position:

1. Buckle harness and chest clip.

2. Loosen harness straps, (see “Harness Use And Adjustment” section).

3. From back of car seat unhook both harness loops from metal harness plate (fig. b).

4. From front of car seat, pull harness straps out through infant			Metal
insert, seat pad, and car seat shell.				(fig. b)
5. From front of car seat, rethread harness straps through infant			Harness Plate
insert (for use with lower slots on seat back only), desired			Metal
harness strap slots of seat pad, and seat back.
Make sure harness straps are not twisted			Rod
and are threaded through matching slot of
infant insert, seat pad and seat back.		Shoulder
6. From back of car seat, route shoulder harness		Harness
straps between plastic seat and metal rod,		Loops
then re-attach harness adjustment loops to
metal harness plate (fig. c).				(fig. c)
Check that loops are completely in slots				Metal
of metal harness plate and under tabs		Tab
on both sides.	40		Harness Plate