Britax Diplomat manual Vehicle Compatibility, Vehicle Safety Belts

Page 12

Vehicle Compatibility

Vehicle Safety Belts

NOTE: The information in this section only applies to installation with vehicle safety belts.

IMPORTANT: Vehicle seats and safety belts differ from vehicle to vehicle. Refer to your vehicle’s owner’s manual for specific information about vehicle safety belts and their use with child restraints. Some vehicles have no seating positions which are compatible with this child restraint or any other child restraint. If in doubt, contact the vehicle manufacturer for assistance.

This child restraint can fit securely in most vehicles using existing vehicle belts. However, some vehicle designs prevent a secure fit of the child restraint due to position of the vehicle belt lower anchorage points.

The owner’s manual for your vehicle will have information on the types of vehicle belts in your vehicle. If your belt type is listed below, select another seating position or use Lower Anchors and Tethers for Children (LATCH) connectors.

A

B

The following types of vehicle belts are not compatible with this child restraint:

Front vehicle belts with top or bottom anchorage points in the door. (Fig. A)

Motor-driven, automatic vehicle belts. (Fig. B)

Lap-shoulder belts that have separate retractors for shoulder section and lap section in which lap section retractor does not lock.

Non-locking, two-point Emergency Locking Retractor (ELR) vehicle belts. Lap-shoulder ELR vehicle belts without use of the lock-off.

NOTE: Refer to your vehicle’s owner’s manual to determine the kind of retractors used in your vehicle and how to operate them.

10

Image 12
Contents Diplomat Page Table of Contents Death or Serious Injury can occur Page Safety Information Important NotesCertification RegistrationWeight Range Rear-Facing Forward-FacingMaximum Height Rear-Facing Installation Aircraft Aircraft InstallationRear-Facing Installation Forward-Facing InstallationFeatures Features Do not discard foam inserts found under the coverVehicle Safety Belts Vehicle CompatibilityVehicle Seating Positions Vehicle Buckle Position Installation Rear Facing Latch InstallationLatch connector Under cover seeInstallation method Each Latch strap tight fig. ERemoval Lap/Shoulder Belt Installation Verify vehicle belt is not twisted, then buckle fig. CInstallation Rear Facing Lap-Belt Installation Do not install with non-locking ELR, 2-point vehicle beltInstallation Rear Facing Installation Forward Facing Installation Forward Facing 1Place child restraint forward facing on vehicle seat Removal Lap-Belt Installation Installation Versa-Tether Safety InformationUsing the Versa-Tether Tether strap into a V shapeTether to an approved anchor point Pull Versa-Tether strap to remove all SlackRear-Facing Tether Connector Strap Energy-Absorbing Tether Switching the Latch Harness Follow instructions for restraint installation with LatchRestraint Functions Storing the Latch Connectors Recline AdjustmentAdjusting the Chest Clip Infant Body PillowChest Clip Fastening the Chest Clip Releasing the Chest ClipHarness Buckle Fastening the Harness Buckle 1Hold harness buckle with one handReleasing the Harness Buckle Harness HeightSecuring Your Child Securing Your ChildSliding pieces apart fig. B Unfasten harness buckle by pressingHarness Height Adjustment Care and Maintenance Cover Removal1Remove infant body pillow Refitting the CoverCleaning the Cover and Pillows Cleaning the ShellSponge Clean using warm water and mild soap Cleaning the HarnessHarness Buckle Removal Rethreading the Harness BuckleCleaning the Harness Buckle Warranty Limited ONE-YEAR WarrantyPage