Britax Diplomat manual Using the Versa-Tether, Tether strap into a V shape

Installation: Versa-Tether®
Using the Versa-Tether
1�	Consult your vehicle’s owner’s manual for
	approved tether-anchorage locations.
2�	Locate the tether on rear of restraint
	and place up and over seat back while
	securing restraint.
3�	Secure child restraint by a seat-belt or
	LATCH system.	A
4�	Lift lock adjuster, then pull to fully extend
	tether strap into a "V" shape.
5�	Locate hook on strap and loosely attach
	tether to an approved anchor point.
•	See figure A for forward-facing installation.
• See figures B and C for rear-facing
	installation.

NOTE: Rear-facing installation may also require
use of Tether Connector Strap, as described on	B
page 25.
6� Pull Versa-Tether strap to remove all
slack.
7� Verify there is tension in Versa-Tether
strap and that child restraint is properly
secured. The restraint is secure when it
cannot be moved front-to-back or side-
to-side more than 1 inch (2.5 cm.) at
belt path. If restraint is not secure, repeat
procedure or use an alternate seating	C
location.

8� Roll up excess webbing and store in tether pouch.

24