Britax Diplomat manual Care and Maintenance, Cover Removal, 1Remove infant body pillow

Page 35

Care and Maintenance

Cover Removal

WARNING! Do not take apart or attempt to take apart the harness. It is unnecessary and dangerous to do so.

Never remove the buckle tongues from the harness. They cannot be reattached after removal.

1�Remove infant body pillow.

2�Loosen harness by pressing adjuster release button while pulling shoulder straps forward as far as possible.

3�Unhook shoulder straps from yoke on rear of child restraint.

4�Pull upper harness straps through headrest and cover to front of restraint.

5�Remove buckle and belly pad (pg. 35).

6�Gently remove headrest cover. Be careful not to damage the energy-absorbing foam.

7�Remove upper portion of cover.

8�Pull lower harness straps, buckle tongues, and chest clip through slots in cover.

9�Remove entire cover from restraint.

Refitting the Cover

To refit the cover, reverse above directions. Make sure that the shoulder straps are threaded through the chest clips and that the harness is not twisted.

33

Image 35
Contents Diplomat Page Table of Contents Death or Serious Injury can occur Page Important Notes Safety InformationRegistration CertificationMaximum Height Rear-Facing Weight Range Rear-FacingForward-Facing Forward-Facing Installation Installation AircraftAircraft Installation Rear-Facing InstallationFeatures Do not discard foam inserts found under the cover FeaturesVehicle Compatibility Vehicle Safety BeltsVehicle Seating Positions Vehicle Buckle Position Under cover see Installation Rear FacingLatch Installation Latch connectorRemoval Installation methodEach Latch strap tight fig. E Verify vehicle belt is not twisted, then buckle fig. C Lap/Shoulder Belt InstallationInstallation Rear Facing Do not install with non-locking ELR, 2-point vehicle belt Lap-Belt InstallationInstallation Rear Facing Installation Forward Facing Installation Forward Facing 1Place child restraint forward facing on vehicle seat Removal Lap-Belt Installation Safety Information Installation Versa-TetherPull Versa-Tether strap to remove all Slack Using the Versa-TetherTether strap into a V shape Tether to an approved anchor pointRear-Facing Tether Connector Strap Energy-Absorbing Tether Restraint Functions Switching the Latch HarnessFollow instructions for restraint installation with Latch Recline Adjustment Storing the Latch ConnectorsReleasing the Chest Clip Adjusting the Chest ClipInfant Body Pillow Chest Clip Fastening the Chest ClipHarness Height Harness Buckle Fastening the Harness Buckle1Hold harness buckle with one hand Releasing the Harness BuckleUnfasten harness buckle by pressing Securing Your ChildSecuring Your Child Sliding pieces apart fig. BHarness Height Adjustment Refitting the Cover Care and MaintenanceCover Removal 1Remove infant body pillowCleaning the Harness Cleaning the Cover and PillowsCleaning the Shell Sponge Clean using warm water and mild soapRethreading the Harness Buckle Harness Buckle RemovalCleaning the Harness Buckle Limited ONE-YEAR Warranty WarrantyPage