Britax Diplomat Infant Body Pillow, Chest Clip Fastening the Chest Clip, Releasing the Chest Clip

Page 31

Restraint Functions

Infant Body Pillow

The Infant Body Pillow is designed to provide better fit and comfort for infants using this restraint. For additional side support, fold side flaps, as shown below. (fig. D)

NOTE: Remove Infant Body Pillow after child can sit comfortably in restraint without additional support.

Chest Clip

Fastening the Chest Clip

Fasten chest clip by pushing the two halves together until a positive click is heard (fig. E).

Releasing the Chest Clip

1�Squeeze middle tabs together.

2�Pull the two pieces apart.

Adjusting the Chest Clip

Slide chest clip up or down on har- ness so it is positioned at the middle of child’s chest, level with child’s armpits.

D

E

29

Image 31
Contents Diplomat Page Table of Contents Death or Serious Injury can occur Page Important Notes Safety InformationRegistration CertificationForward-Facing Weight Range Rear-FacingMaximum Height Rear-Facing Forward-Facing Installation Installation AircraftAircraft Installation Rear-Facing InstallationFeatures Do not discard foam inserts found under the cover FeaturesVehicle Compatibility Vehicle Safety BeltsVehicle Seating Positions Vehicle Buckle Position Under cover see Installation Rear FacingLatch Installation Latch connectorEach Latch strap tight fig. E Installation methodRemoval Verify vehicle belt is not twisted, then buckle fig. C Lap/Shoulder Belt InstallationInstallation Rear Facing Do not install with non-locking ELR, 2-point vehicle belt Lap-Belt InstallationInstallation Rear Facing Installation Forward Facing Installation Forward Facing 1Place child restraint forward facing on vehicle seat Removal Lap-Belt Installation Safety Information Installation Versa-TetherPull Versa-Tether strap to remove all Slack Using the Versa-TetherTether strap into a V shape Tether to an approved anchor pointRear-Facing Tether Connector Strap Energy-Absorbing Tether Follow instructions for restraint installation with Latch Switching the Latch HarnessRestraint Functions Recline Adjustment Storing the Latch ConnectorsReleasing the Chest Clip Adjusting the Chest ClipInfant Body Pillow Chest Clip Fastening the Chest ClipHarness Height Harness Buckle Fastening the Harness Buckle1Hold harness buckle with one hand Releasing the Harness BuckleUnfasten harness buckle by pressing Securing Your ChildSecuring Your Child Sliding pieces apart fig. BHarness Height Adjustment Refitting the Cover Care and MaintenanceCover Removal 1Remove infant body pillowCleaning the Harness Cleaning the Cover and PillowsCleaning the Shell Sponge Clean using warm water and mild soapRethreading the Harness Buckle Harness Buckle RemovalCleaning the Harness Buckle Limited ONE-YEAR Warranty WarrantyPage