Allstar Products Group HDSWG 1000 owner manual Pre-Setting the Motor Overload Sensitivity

Page 2

TABLE OF
Pre-Installation Notes	3
Section A: Installation Notes	4
Section B: Preparing the Site	6
The Concrete Operator Pad	6
Placing the Vehicle Detector Loops	6
Electrical Power Requirements	8
Section C: Installing the Operator	9
Placing the Mechanical Unit	10
Installing the Arm	10
Installing the Control Box	11
Electrical Hookup	11
Connecting the Mechanical Unit to the Control Box	12
Bi-Parting Wiring Diagrams	13
Accessory Equipment Hookup	15
Wiring Diagram	13
Terminal Strip Reference Chart	18
Section D: Starting the Operator	19
Setting the Limit Switches	19
Pre-Setting the Motor Overload Sensitivity	19
Setting the Switch Selectable Options	19
Applying Power	20
Maximum Run Timer	22
Final Settings	22
Section E: Auxiliary Equipment	20
Section F: Safety Guide	21
Operator Exploded View & Parts List	23
Technical Specifications	24

READ THESE STATEMENTS CAREFULLY AND FOLLOW THE

INSTRUCTIONS CLOSELY.

The Warning and Caution boxes throughout this manual are there to protect you and

your equipment. Pay close attention to these boxes as you follow the manual.

WARNING

Indicates a MECHANICAL

hazard of INJURY OR

DEATH. Gives instructions

to avoid the hazard.

CAUTION

Indicates a MECHANICAL hazard

of DAMAGE to your gate, gate operator, or equipment. Gives instructions to avoid the hazard.

WARNING

Indicates an ELECTRICAL

hazard of INJURY OR

DEATH. Gives instructions

to avoid the hazard.

CAUTION

Indicates an ELECTRICAL hazard of DAMAGE to your gate, gate operator, or equipment. Gives instructions to avoid the hazard.

2

Image 2

Contents Hdswg Pre-Setting the Motor Overload Sensitivity PRE-INSTALLATION LOG Date Overload Test Date Tested Dates Operator ServicedGate System Design and Installation Safety Check List Swing Gate Entrapment Protection Important Installation NotesAS the Installer YOU are Responsible for Concrete PADPreparing the Site Placing the Vehicle Detector LoopsElectrical Power Requirements Vehicle Detector Loop Blanking for Swing GatesOther Voltages and Three Phase Systems Service ConduitInstalling Tools RequiredInstalling the Hdswg 1000 ARM Placing the Hdswg 1000 Mechanical UnitElectrical Hook UP Installing the OperatorInstalling the Hdswg 1000 Control BOX BI-PARTING Wiring Connecting the AC WiringConnecting the Mechanical Unit to the Control BOX Volt InstallationsLeft/Right Hand Installation Limit & Motor Wiring Diagram Bi-Parting Installation Limit & Motor Wiring Diagram Accessory Equipment HOOK-UP Wiring Radio Receivers to the Terminal StripThree Terminal Receivers Four Wire ReceiversWiring a 3-BUTTON Station Wiring Vehicle Detectors Wiring a KEYPAD, Card Reader or Telephone Entry SystemVehicle Detector Power Connecting the Vehicle Detector to the Hdswg# Name DescriptionPresetting the Motor Overload Sensitivity Setting the Limit Switches RIGHT-HANDED OperationSetting the Limit Switches LEFT-HANDED Operation Setting the Switch Selectable OptionsPRE-POWER Check List Applying Power to the HdswgTimer to Close Setting Checking the Indicator LightsPRE POWER-ON Checklist Running the HdswgFinal Setting of the Motor Overload Sensitivity Maximum RUN TimerFinal Setting of the Close Timer Installation Notes for Auxiliary Equipment Vehicle DetectorsGate Opener System Operation & Safety Guide Precautions for Pedestrian Traffic or Residential AreasMaintain ALL Components of Gate System Gate Opener System Operation & SafetyMaintain the Gate and Gate Hardware a Mechanical Unit Exploded View Hdswg 1000 Mechanical Unit Exploded ViewMechanical Unit Parts List ARM KIT & Control BOX Exploded View & PartsElectrical Technical SpecificationsPhysical Drive Capacities