Playback
■Enjoying pure hi-fi stereo sound
The DIRECT STEREO mode allows sources to bypass the decoders and DSP processors of this unit so that you can enjoy pure
Press CDIRECT STEREO (or press D AMP and then press V DIRECT ST.) to select “DIRECT
STEREO”.
Notes
•To avoid unexpected noise, do not play CDs encoded in DTS when the DIRECT STEREO mode is selected.
•When
•No sound will be output from the subwoofer.
•“TONE CONTROL” (on this page) and “SOUND MENU” (see page 48) settings (except for speaker level settings) are not effective.
•The front panel display automatically dims.
■Adjusting the tonal quality
Press 0TONE CONTROL repeatedly to select “BASS” or “TREBLE” and then press
APROGRAM l / h (or J PROGl / h) to
adjust the corresponding frequency response level.
•Select “BASS” to adjust the
•Select “TREBLE” to adjust the
Notes
•Speaker and headphone adjustments are stored independently.
•If you increase or decrease the
■Adjusting speaker levels during
playback
You can adjust the output level of each speaker while listening to a music source.
Note
This operation will override the level adjustments made in “AUTO SETUP” (see page 24) and “SP LEVEL” (see page 50).
1Press D AMP and then press F LEVEL repeatedly to select the speaker you want to adjust.
Display | Adjusted speaker |
FRONT L | Front left speaker |
|
|
FRONT R | Front right speaker |
|
|
CENTER | Center speaker |
|
|
SWFR | Subwoofer |
|
|
SUR.L | Surround left speaker |
|
|
SUR.R | Surround right speaker |
|
|
y
Once you press F LEVEL on the remote control, you can also select the speaker by pressing G k / n.
2Press G l / h on the remote control to adjust the speaker output level.
The control range is from +10 dB to –10 dB.
y
You can press 4A/B/C/D/E to select a speaker and then 5PRESET/TUNING l / h to adjust the speaker output level.