Using multi-zone configuration
This unit allows you to configure a
Only analog signals are sent to the second zone. Any source you want to listen to in the second zone must be connected to the analog AUDIO IN jacks of this unit.
Connecting Zone 2
You need the following additional equipment to use the
•An infrared signal receiver in the second zone.
•An infrared signal emitter in the main zone. This emitter transmits the infrared signals from the remote control via the infrared signal receiver in the second zone to a CD player or a DVD player, etc. in the main zone.
•An amplifier and speakers in the second zone.
y
•Since there are many possible ways to connect and use this unit in a
•Some Yamaha models are able to connect directly to the REMOTE jacks of this unit. If you own these products, you may not need to use an infrared signal emitter. Up to 6 Yamaha components can be connected as shown below.
REMOTE |
| REMOTE |
| REMOTE |
| REMOTE | ||
IN |
| OUT | IN |
| OUT | IN |
| OUT |
|
|
| ||||||
|
|
|
|
|
|
|
|
|
Infrared signal | This unit |
|
| Yamaha |
| Yamaha | ||
receiver |
|
|
| component |
| component |
■Using the external amplifier
Connect the amplifier/receiver in the second zone and other components to this unit as follows.
OPERATION | ADVANCED |
|
|
From the ZONE 2 OUT jacks
| Main zone |
DVD player | This unit |
| Infrared signal emitter |
Amplifier
Second zone
(Zone 2)
Infrared signal receiver Remote control
From the REMOTE OUT jacks | From the REMOTE IN jacks |
Note
To avoid unexpected noise, DO NOT USE the Zone 2 feature with CDs encoded in DTS.
English