Troubleshooting
■Remote control
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
The remote control | Wrong distance or angle. | The remote control functions within a maximum | 25 | |
does not work nor |
| range of 6 m (20 ft) and no more than 30 degrees off- |
| |
function properly. |
| axis from the front panel. |
| |
|
|
|
| |
| Direct sunlight or lighting (from an | Reposition this unit. | — | |
| inverter type of fluorescent lamp, etc.) is |
|
| |
| striking the remote control sensor of this |
|
| |
| unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries. | 3 | |
|
|
|
| |
| The remote control code is not correctly | Set the remote control code correctly using “List of | 78 | |
| set. | remote control codes” at the end of this manual. |
| |
|
|
|
| |
|
| Try setting another code for the same manufacturer | 78 | |
|
| using “List of remote control codes” at the end of this |
| |
|
| manual. |
| |
|
|
|
|
Even if the remote control code is correctly set, there are some models that do not respond to the remote control.
■Resetting the system
Use this feature to reset all the parameters of this unit to the initial factory settings.
1Press C SYSTEM OFF on the front panel to set this unit to the standby mode.
2Press and hold N TONE CONTROL and then press A MAIN ZONE ON/OFF to turn
on this unit.
The advanced setup menu appears in the front panel display.
3Press O PROGRAM l / h to select “INIT.”.
4Press P STRAIGHT repeatedly to select “RESET”.
Select “CANCEL” to cancel the initialization procedure without making any changes.
5Press A MAIN ZONE ON/OFF to confirm your selection and set this unit to the standby mode.
Notes
•This procedure completely resets all the parameters of this unit including the “SET MENU” parameters. However, the advanced setup menu parameters will not be initialized.
•The initial factory settings are activated next time you turn on this unit.
y
To cancel the initialization procedure at any time without making any changes, press P STRAIGHT repeatedly to select “CANCEL” and then press
INFORMATION | ADDITIONAL |
|
|
English