JAI TS-2030EN, TS-9720EN, TS-1327EN manual Table of Contents

	VIS-CAM System
	Table of Contents
1	Introduction	1
1.1	Document Overview	1
1.2	Product overview	1
1.3	System Components description	2
1.3.1	Traffic Light Sensor – TLS300	2
1.3.2	VISCAM	3
1.3.3	Illumination	4
1.3.4	VJP-300 Junction Panel	4
1.3.5	RS485 Device Server	4
1.3.6	ENSetup Program	4
1.4	Operational Overview	4
1.4.1	Trigger Mode	4
2	Preparing for installation	5
2.1	Installation Preparation	5
2.1.1	Over Lane Positioning	5
2.1.2	Side of Road Installation	14
3	Installing the Vehicle Imaging System	17
3.1	Installing the TNF-300 Traffic Light Sensor	17
3.1.1	To install the Traffic Light Sensor:	17
3.1.2	Optional Side Mount	19
3.2	Installing the Camera(s)	19
3.3	Installing the J-Panel	23
3.3.1	X1 and X2 VIS CAM 300/400	23
3.3.2	X3, X7 Traffic Light Sensor	24
3.3.3	X6 Power Input Connector	25
3.3.4	X8 LS RS485 Out Connector	26
3.3.5	X14 Trigger Input Connector	27
3.3.6	X15 Lane Controller Connector (X4 and X5)	28
3.4	Illumination Options	29
3.4.1	Installing the TNF-31 Flash	29
3.5	Trigger Options	30
3.5.1	Installing The Laser Vehicle Detector	30
4	System Set-Up	33
4.1	Preparation for Alignment	33
4.1.1	Pre-Alignment Checklist	33
4.1.2	Select a Suitable Vehicle, License Plate, and Plate Stand for the Setup	34
4.1.3	Select the Camera to Align	34
4.1.4	Validate the Installation Geometry	34
4.1.5	Edit the alignment settings on the Setup Computer	34
4.1.6	Connect the Setup Computer to the Camera	35
4.1.7	Drive and Park the Setup Vehicle Correctly	36
4.1.8	Properly Position the License Plate Stand	36
4.1.9	Perform Initial Lens Adjustment and Camera Aiming	36
4.1.10 Finalize Lens Adjustments and Camera Aiming		39
4.1.11	Flash Head Alignment	42
5	Appendix A: Camera Functional and Connector Description	45
5.1	I/O Board Layout	46
5.2	X4: I/O Board Connection to J-panel	47
5.2.1	Functionality	47
5.2.2	Connector specification	47

Table of Contents v