Hitachi V-21W operating instructions Auto white balance error messages, White balance memory

White and black balance adjustment

Auto white balance error messages

If auto white balance adjustment fails, the following error messages appear on the viewfinder screen for about 6 seconds.

Message	Cause	Correction
	Output switch set to BAR.	Change switch setting to CAM and readjust.
AUTO WHITE : NG
CHANGE TO CAM
TRY AGAIN
	White BAL switch at PRE, or Full Auto	Set White BAL switch to A or B, or Full Auto
AUTO WHITE : NG	is on (local mode).	to off, then readjust.
CHANGE WHITE BAL TO A/B
TRY AGAIN
	White BAL switch not at MEM (remote	Set switch to MEM and readjust.
AUTO WHITE : NG	mode).
CHANGE WHITE BAL TO MEM
TRY AGAIN
	Lighting insufficient for adjustment.	Increase the lighting or set the Gain switch to
AUTO WHITE : NG		M or H. If manual iris lens, adjust the lens.
LOW LIGHT
		Then repeat white balance adjustment.
TRY AGAIN
	Excessive lighting for adjustment.	Set Gain switch to a lower position.
AUTO WHITE : NG		If manual iris lens, adjust the lens.
LEVEL HIGH
		Then repeat white balance adjustment.
TRY AGAIN
	Color temperature too high for
AUTO WHITE : NG
	adjustment.
C.TEMP HIGH
CHANGE FILTER		Change optical filter and readjust.
TRY AGAIN
	Color temperature too low for
AUTO WHITE : NG
	adjustment.
C.TEMP LOW
CHANGE FILTER
TRY AGAIN
	Tally lamp lighted.	While lighted, again set the Auto W/B BAL
AUTO WHITE :		switch to AWB and begin adjustment.
TALLY ON
EXECUTE?

When the above error messages appear, correct the settings and repeat white balance adjustment.

White balance memory

The adjustment values for each folder can be automatically stored in the respective memory (A or B) according to the White BAL switch setting. The total of 4 folders allows storing 8 adjustment values.

37