Lens flangeback adjustment
When operating a zoom lens, if the focus is not precisely aligned at both the telephoto and wide angle extremes of the lens, the flangeback (distance from the lens mounting plane to the focal plane) is adjusted. This adjustment is generally required only once unless the lens is replaced.
Reference
Refer to the lens operating instructions regarding the component positions for flangeback adjustment.
Flangeback adjustment
1.Set the lens iris for manual operation.
2.Open the iris. Set a flangeback adjusting chart about 3 meters distant and adjust the lighting to obtain the correct video output level. If the video level is too high, use a CC/ND filter or electronic shutter.
3.Loosen the Ff ring setscrew.
4.By hand or motor, set the zoom ring to the telephoto position.
5. Observe the flangeback chart image and
turn the distance ring to adjust the focus.
6.Set the zoom ring to the wide angle position.
7.Turn the Ff ring and adjust the focus. Use care not to turn the distance ring.
8.Repeat this process until focus is obtained at both telephoto and wide angle settings.
9.Securely tighten the Ff ring setscrew.
● Also, see the lens operating instructions.
14