Fujitsu RX600 S4 manual Procedure

Page 9

2 Procedure

VCAUTION!

●The actions described in this manual should only be performed by engineers, service personnel or technical specialists.

●Equipment repairs must only be performed by qualified staff.

●Any failure to observe the guidelines in this manual, and any unautho- rized opening or improper repairs could endanger the user (through electric shock, fire hazards) or damage the equipment.

●Please note that any unauthorized opening of the server will void the warranty and exempt the manufacturer from all liability.

ÊFirst of all please familiarize yourself with the safety instructions in the chapter “Safety instructions” on page 11ff.

ÊMake sure that all the manuals you need (see “Additional documentation about the server” on page 6) are available, printing out the PDF files if necessary.

You will definitely need:

–the operating manual for the server,

–the service supplement for the server, and

–the technical manual for the system board.

ÊShut down the server correctly, switch it off, pull out the power plugs, and open the server as described in the chapter “Preparation” on page 17f.

ÊExtend or upgrade your server as described in the relevant chapter.

IThe installation and removal of the hot-plug components is described in the operating manual supplied with the server.

ÊClose the server, plug in the power plugs, and switch on the server as described in the chapter “Completion” on page 47f.

ÊStart the operating system and, if necessary, configure it as required (see the operating manual).

RX600 S4

Options Guide

9

Image 9

Contents Primergy RX600 S4 Server Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections…Contents Contents Preface Concept and target group of this manualDocumentation overview Further sources of information Extensions and conversions Notational conventions Preface ServerView Remote Management Notational conventionsProcedure Page Before starting up Safety instructionsInstallation and operation Safety instructions Working with CDs/DVDs and CD/DVD drives BatteriesLaser information RX600 S4 Opening the server PreparationOpening the server Preparation Removing the housing coverMain memory Page Processors Installing additional processorsRemoving the processor cover Installing additional processorsRemoving the dummy heat sink ProcessorsOpening the socket lever Installing the processorFastening the heat sink Installing the heat sinkMounting the processor cover Mounting the processor coverRemoving the heat sink Replacing a processorReplacing a processor Installing the new processorProcessors Page Accessible drives Installing the CD/DVD driveRemoving the module frame Mounting a CD/DVD drive Installing the CD/DVD driveMounting the drive in its frame Accessible drivesConnecting a CD/DVD drive Installing a tape drive Module frame with sliding rails Installing a tape driveFastening the sliding rails on the drive Mounting the tape drive Connecting the tape driveCable routing from the tape to the PCI controller Page Controllers in non-hot-plug PCI slots Installing controllersInstalling a controller in a non-hot-plug PCI slot Installing controllersInstalling the battery iBBU Battery for the RAID5 controllerPosition of the SAS riser card in the server Installing the battery iBBUSAS riser card top and battery iBBU bottom Battery for the RAID5 controllerPage Closing the server CompletionPage Abbreviations Abbreviations EMP IBBU LED PS/2 RoHSRoMB SBE VRM RAID5 Index