Fujitsu RX600 S4 manual Processors, Installing additional processors

Page 21

6 Processors

VCAUTION!

Make sure you observe the safety notes in the chapter “Safety instruc- tions” on page 11ff.

Processors are components which are extremely sensitive to electro- static discharge and must therefore be handled with caution.

After removing a processor from its protective wrapper or from a socket, always place it on an insulated, antistatic surface and always with the smooth side down.

Never slide a processor over a surface.

6.1Installing additional processors

The system board can be upgraded to include up to four processors.

VCAUTION!

If you fit CPU sockets 2-4, you must observe the following:

1.If you install a total of two CPUs, you must use the CPU sockets of CPU 1 and CPU 2.

2.If you install a total of three CPUs, you must use the CPU sockets of CPU 1, CPU 2 and CPU 4 (not CPU 3!).

3.If you install a total of four CPUs, you must use the CPU sockets of CPU 1 through CPU 4.

Always use processors of the same type. All processors must have the same frequency and cache size. For multi-processor operation, you must use a suitable multi-processor operating system.

ÊOpen the server as described in the chapter “Preparation” on page 17f.

RX600 S4

Options Guide

21

Image 21

Contents Primergy RX600 S4 Server Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections…Contents Contents Preface Concept and target group of this manualDocumentation overview Further sources of information Extensions and conversions Notational conventions Preface ServerView Remote Management Notational conventionsProcedure Page Before starting up Safety instructionsInstallation and operation Safety instructions Working with CDs/DVDs and CD/DVD drives BatteriesLaser information RX600 S4 Opening the server PreparationOpening the server Preparation Removing the housing coverMain memory Page Processors Installing additional processorsRemoving the processor cover Installing additional processorsRemoving the dummy heat sink ProcessorsOpening the socket lever Installing the processorFastening the heat sink Installing the heat sinkMounting the processor cover Mounting the processor coverRemoving the heat sink Replacing a processorReplacing a processor Installing the new processorProcessors Page Accessible drives Installing the CD/DVD driveRemoving the module frame Mounting a CD/DVD drive Installing the CD/DVD driveMounting the drive in its frame Accessible drivesConnecting a CD/DVD drive Installing a tape drive Module frame with sliding rails Installing a tape driveFastening the sliding rails on the drive Mounting the tape drive Connecting the tape driveCable routing from the tape to the PCI controller Page Controllers in non-hot-plug PCI slots Installing controllersInstalling a controller in a non-hot-plug PCI slot Installing controllersInstalling the battery iBBU Battery for the RAID5 controllerPosition of the SAS riser card in the server Installing the battery iBBUSAS riser card top and battery iBBU bottom Battery for the RAID5 controllerPage Closing the server CompletionPage Abbreviations Abbreviations EMP IBBU LED PS/2 RoHSRoMB SBE VRM RAID5 Index