Fujitsu RX600 S4 Battery for the RAID5 controller, SAS riser card top and battery iBBU bottom

Page 45

Battery for the RAID5 controller

Installing the battery (iBBU)

A

B

Figure 28: SAS riser card (top) and battery iBBU (bottom)

ÊPlug the connector (B) of the battery onto the connector (A) on the SAS riser card.

ÊFasten the battery to the SAS riser card with the three supplied screws.

ÊClose the server, plug in the power plugs, and switch on the server as described in the chapter “Completion” on page 47f.

RX600 S4

Options Guide

45

Image 45
Contents Primergy RX600 S4 Server Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections…Contents Contents Preface Concept and target group of this manualDocumentation overview Further sources of information Extensions and conversions Notational conventions Preface ServerView Remote Management Notational conventionsProcedure Page Before starting up Safety instructionsInstallation and operation Safety instructions Working with CDs/DVDs and CD/DVD drives BatteriesLaser information RX600 S4 Opening the server PreparationOpening the server Preparation Removing the housing coverMain memory Page Processors Installing additional processorsRemoving the processor cover Installing additional processorsRemoving the dummy heat sink ProcessorsOpening the socket lever Installing the processorFastening the heat sink Installing the heat sinkMounting the processor cover Mounting the processor coverRemoving the heat sink Replacing a processorReplacing a processor Installing the new processorProcessors Page Accessible drives Installing the CD/DVD driveRemoving the module frame Mounting a CD/DVD drive Installing the CD/DVD driveMounting the drive in its frame Accessible drivesConnecting a CD/DVD drive Installing a tape drive Module frame with sliding rails Installing a tape driveFastening the sliding rails on the drive Mounting the tape drive Connecting the tape driveCable routing from the tape to the PCI controller Page Controllers in non-hot-plug PCI slots Installing controllersInstalling a controller in a non-hot-plug PCI slot Installing controllersInstalling the battery iBBU Battery for the RAID5 controllerPosition of the SAS riser card in the server Installing the battery iBBUSAS riser card top and battery iBBU bottom Battery for the RAID5 controllerPage Closing the server CompletionPage Abbreviations Abbreviations EMP IBBU LED PS/2 RoHSRoMB SBE VRM RAID5 Index