EverFocus EPTZ900 user manual Relay

Page 22

2.Thread the cable through the hole in the wall mount bracket, and screw in 4 M8 nuts for mounting the bracket.

3.Take off the housing from the packing, and take off the baseboard (4 bolts on it.) inside the housing. Thread the cable through the top of the housing. Fix the housing on the wall mount bracket, and screw in 3 M5 bolts (Hex) on the top of the bracket with the attached Hex Allen wrench to fix the housing.

M5 Bolt

Hex Allen wrench

RELAY

JP5

Video +

Video -

RS485 +

RS485 -

AC24

AC24

JP6 JP4

JP3 JP1

4.Connect the cable connectors to the nodes on the baseboard, and then fix the baseboard in the housing by screwing 4 bolts on it.

Notice: Please notice the polarity of control line. The EPTZ900 will not work if the polarity of control line is mis-connected.

2-21

Image 22

Contents EPTZ900/500 Table of Contents EPTZ900/500 Function Setup and Operation Structure of the Setup Menu Camera Setup MenuEPTZ900/500 Overview IntroductionPage EPTZ900 EPTZ500 CE FCC Feature Profile of EPTZ900/500 EPTZ500Relay EPTZ900 BaseboardRelay EPTZ500 Baseboard EPTZ900/500 Control BoardEPTZ900/500 EPTZ900/500 Quick Operation Guide Work with EKB500 Cable Needed Power Cable Packing ListVideo Cable ID1 Page Address EVF 1 PELCO-D PELCO-P TYPE-A OFF CAM-0 CAM-1 Rack and Speed Dome Installation Installation Requirements Relay Glove Turn on the power, and start to operate the EPTZ900 Cut the ceiling Page Glove Separately Sold Accessories Pole mount EPTZ900/500 Camera Setup Menu Structure of the Setup MenuCamera Setup Menu Page Page Page EPTZ900/500 Function Setup and Operation Manual Control ModeTour Mode ¾ Set an alarm link ¾ Delete an alarm linkEPTZ900 base board Pin # FunctionAppendix B Protocol Function CMD2 IDH IDL DATA1 Char Coor=0-19 Char=ASCII code EverFocus Electronics Corp