EverFocus user manual Relay, EPTZ900 Baseboard

Page 9

1.3.2. Base Board

The base board that is on the bottom of the housing connects to power cable, video cable, control cable, alarm cable, fan and heater (fan and heater are for EPTZ900 only). In order to connect to cables, the board needs to be taken off, and put back after finishing connecting to all cables. The connectors of cable names are marked on the board in white text. The details of the alarm connector (JP5) are shown on the APPENDIX A.

For EPTZ900, JP1, JP3 and JP6 that are two-pin connectors on the base board need to be taken off during installation. JP1 and JP3 are connectors for heater, and they can be switched. JP6 is a fan controller connector that turns on/off of the fan. The 3 cables are too short to be connected to a wrong connector when putting them back.

RELAY

JP5

Video +

Video -

RS485 +

RS485 -

AC24

AC24

JP6 JP4

JP3 JP1

EPTZ900 Baseboard

1-8

Page 8 Page 10
Image 9
Page 8 Page 10
Contents EPTZ900/500 Table of Contents Structure of the Setup Menu Camera Setup Menu EPTZ900/500 Function Setup and OperationIntroduction EPTZ900/500 OverviewPage EPTZ900 EPTZ500 CE FCC EPTZ500 Feature Profile of EPTZ900/500EPTZ900 Baseboard RelayEPTZ500 Baseboard EPTZ900/500 Control Board RelayEPTZ900/500 EPTZ900/500 Quick Operation Guide Work with EKB500 Packing List Cable Needed Power CableVideo Cable ID1 Page Address EVF 1 PELCO-D PELCO-P TYPE-A OFF CAM-0 CAM-1 Rack and Speed Dome Installation Installation Requirements Relay Glove Turn on the power, and start to operate the EPTZ900 Cut the ceiling Page Glove Separately Sold Accessories Pole mount Structure of the Setup Menu EPTZ900/500 Camera Setup MenuCamera Setup Menu Page Page Page Manual Control Mode EPTZ900/500 Function Setup and OperationTour Mode ¾ Delete an alarm link ¾ Set an alarm linkPin # Function EPTZ900 base boardAppendix B Protocol Function CMD2 IDH IDL DATA1 Char Coor=0-19 Char=ASCII code EverFocus Electronics Corp
Top Page Image Contents