EverFocus EPTZ900 user manual

Page 26

Notice: Please notice the polarity of control line. The EPTZ500 will not work if the polarity of control line is mis-connected.

6.Align the two screw holes on the bottom of mechanical part to the two bolts on the base of the housing, and twist the mechanical part clockwise a little bit in order to engage it with the base. Screw the two bolts on the base, and then connect and fix the connection bus to the PCB board on the mechanical part.

Notice: The camera module on the mechanical part is very sensitive. Please be careful when installing this part.

7.Remove the lens protection cover before installing the bulb. Screw the connection wire to the housing in order to prevent the bulb from being drop down. Align the 2 buttons on the bulb base with the 2 buttons on the housing, and push bulb base to clip the housing.

2-25

Image 26

Contents EPTZ900/500 Table of Contents EPTZ900/500 Function Setup and Operation Structure of the Setup Menu Camera Setup MenuEPTZ900/500 Overview IntroductionPage EPTZ900 EPTZ500 CE FCC Feature Profile of EPTZ900/500 EPTZ500Relay EPTZ900 BaseboardRelay EPTZ500 Baseboard EPTZ900/500 Control BoardEPTZ900/500 EPTZ900/500 Quick Operation Guide Work with EKB500 Cable Needed Power Cable Packing ListVideo Cable ID1 Page Address EVF 1 PELCO-D PELCO-P TYPE-A OFF CAM-0 CAM-1 Rack and Speed Dome Installation Installation Requirements Relay Glove Turn on the power, and start to operate the EPTZ900 Cut the ceiling Page Glove Separately Sold Accessories Pole mount EPTZ900/500 Camera Setup Menu Structure of the Setup MenuCamera Setup Menu Page Page Page EPTZ900/500 Function Setup and Operation Manual Control ModeTour Mode ¾ Set an alarm link ¾ Delete an alarm linkEPTZ900 base board Pin # FunctionAppendix B Protocol Function CMD2 IDH IDL DATA1 Char Coor=0-19 Char=ASCII code EverFocus Electronics Corp