EverFocus EDN850H user manual AREA1 AREA2 AREA3 AREA4

Page 36

EDN850H

zPlease use the UP or DOWN button to move between TOP, DOWN, LEFT and RIGHT for adjusting the size of the area.

zPlease use the LEFT or RIGHT button to adjust the value for size of the area.

AREA1

AREA2

AREA3

AREA4

zAdditionally, it is possible to change the position of the area. Please refer to the following example for detailed steps on moving AREA1 to center.

1.The original position of AREA1 was TOP: 10, DOWN: 25, LEFT: 20 and RIGHT: 40.

AREA1

2.Increase DOWN scale value by 20. AREA1 position after change is: TOP: 10,

DOWN: 45, LEFT: 20 and RIGHT: 40.

AREA1

36

Image 36

Contents EDN850H EDN850H Safety Notice EDN850H About this documentTerms and Trademark SupportAbout AC Adaptor Table of Contents EDN850H Introduction Accessing the Camera Menu EDN850H EDN850H Setting System Info Information2 Log User Config EDN850H Network NetworkIP Type IP addressSubnet Mask GatewayPassword EDN850H Primary DNSSecondary DNS UsernameEDN850H Bandwidth SMTP/FTP EDN850H Network Alarm reserved for PowerCon VideoMulti Streaming Camera SET button EDN850H 4.4.2.1 Lens ShutterPress SET button when you finish all the settings EDN850H 4.4.2.3 White Balance Control EDN850H 4.4.2.4 Backlight AGC Auto Gain ControlEDN850H 4.4.2.6 DNR Dynamic Noise Reduction EDN850H 4.4.2.7 SENS-UP EDN850H 4.4.2.8 Special Color ADJ Adjust the Color Gain from 0 ~ Motion Detection AREA1 AREA2 AREA3 AREA4 EDN850H Privacy TOP EDN850H Color ADJ Level Exit Audio User Event Event EDN850H Motion Alarm Time Mask EDN850H System Date/TimeEDN850H Daylight Saving SD Card Indication Description Maintenance BrowseEDN850H Specifications Physical Head Office China Office USA OfficeEurope Office USA N.Y. Office